Is there a repair company for my Raypak pool?
Check out this page on Raypak and see if there is a repair company by you. Yes I know it’s an old heater not under warranty but as long as it’s not the same company you had out, you might be able to get it fixed or find some other company close by that can come by and check it out.
Why is my Raypak RP 2100 pool heater not working?
Anything else is bad. The two main causes for this are a windy condition or the heat exchanger got sooted up and is preventing exhaust from escaping. This sometimes happen if the heater was not given any preventative maintenance at this age.
How can I tell if my Raypak pool heater is shot?
It takes a tool called a manometer to determine if a regulator is shot. This measures gas pressures when the system is static and when it is in use. When in use, the gas pressure on the input side will drop some. I have to wonder if the tech had heater training.
What’s the difference between Houshold and Raypak pool heaters?
Pool heaters are no different in operation than houshold boilers and in some cases are simpler in operation. All the same parts are used as far as igniters, control boards, powerpiles etc and sometimes if not most they are cheaper. A couple examples come to mind. I recently replaces a rollout sensor on a pool heater.
When did my Raypak pool heater come on?
Moderator – Marty Was wondering if someone could please help me out on this; I have a Raypak Natural Gas Heater (auto start) bought and installed in 2013 and just turned it on to heat the pool and it’s reading “Rollout SW Open”.
Is the rollout switch on my Raypak 156 open?
I have a Raypak 156 heater on my spa powered by propane. I replaced the rollout switch, but it opened again after a few uses, suggesting the switch was doing its job properly. Makeup air seemed unobstructed, and the exhaust flue was clean, so I decided to bite the bullet and dig into the heater guts. Following the Raypak YouTube instructions
Why does my Raypak hot water heater not ignite?
I do not understand why Raypak would have a spark igniter AND a pilot. If the unit continues to spark after the pilot is lit, you most likely have a bad system board. A lot of home furnaces are done the same way. It has to do with how the flame proving circuit works for that style of control board.
Is the Jandy part the same as the Raypak heater?
Historically, the exact same Jandy part (R0012200) is a fraction of what Raypak had wanted. Shine a light down from the top, and take that picture again. It will give you an idea of how obstructed it is.
