Is the Sweetwater hot tub covered by warranty?
Damage caused by exposing the hot tub to this abuse is not covered by warranty. We recommend that you always keep the hot tub full of water when it is exposed to direct sunlight and that you keep the Sweetwater insulating cover in place at all times when the hot tub is not in use.
Which is Sweetwater Spa offers the best hot tub?
Sweetwater Spas constantly strives to offer the finest hot tub available, therefore modifications and enhancements may be made which affect the specifications, illustrations and/or instructions contained herein. FCC Notice
What kind of spa parts does Sundance have?
We have spa parts for all Sundance Spas models such as maxxus, maximus, optima, cameo, majesta, altamar, capri, caprio, hamilton, chelsee, aspen, certa, montclair, dover, denali, tacoma, ramona, peyton, mckinley, burlington, bahia, palermo, kingston, claremont 2009 Jacuzzi® Hot Tub Model J-480 OEM Circuit Board Control 850 LCD PWA 850 NT ::809.
Damage caused by exposing the hot tub to this abuse is not covered by warranty. We recommend that you always keep the hot tub full of water when it is exposed to direct sunlight and that you keep the Sweetwater insulating cover in place at all times when the hot tub is not in use.
What to do if your spa unit has er-3 error message?
Heater has been active and has had insufficient water flow over the element. Low or no water flow has caused the heater temperature to exceed its maximum limits and the spa control has shut down operation to prevent any damage to the heater unit Turn mains power OFF and wait 10-15 minutes for element to cool and thermal cut-out device to reset.
Where to find support base for Sweetwater hot tub?
Read and carefully follow the requirements for your hot tub’s support base (found in the section titled, “Locating Your Sweetwater Hot Tub”, page 8).
What to do if your spa unit goes down?
Low or no water flow has caused the heater temperature to exceed its maximum limits and the spa control has shut down operation to prevent any damage to the heater unit Turn mains power OFF and wait 10-15 minutes for element to cool and thermal cut-out device to reset. Then turn power back ON
What does it mean when spa is shut down?
SnS = Sensors out of balance. If alternating with temp, may be temporary condition. If display shows only this message (blinking) spa is shut down. HFL = Substantial difference between temperature sensors detected. Could indicate a flow problem. LF = Persistent low flow problems. (Displays on the 5th occurrence of “HFL” message with 24 hours).
Read and carefully follow the requirements for your hot tub’s support base (found in the section titled, “Locating Your Sweetwater Hot Tub”, page 8).
What is the error code for the spa?
PSoL = Pressure switch open with low pump. PSoH = Pressure switch open with high pump. ToE = Time out error. Rare system error. Spa unusable. Contact ACC. OHH = Overheat. Spa has shut down. One sensor has detected 118º Fat heater. OHS = Overheat. Spa has shut down. One sensor has detected 110ºF. SnA = Spa is shut down.
Sweetwater Spas constantly strives to offer the finest hot tub available, therefore modifications and enhancements may be made which affect the specifications, illustrations and/or instructions contained herein. FCC Notice
We have spa parts for all Sundance Spas models such as maxxus, maximus, optima, cameo, majesta, altamar, capri, caprio, hamilton, chelsee, aspen, certa, montclair, dover, denali, tacoma, ramona, peyton, mckinley, burlington, bahia, palermo, kingston, claremont 2009 Jacuzzi® Hot Tub Model J-480 OEM Circuit Board Control 850 LCD PWA 850 NT ::809.
Why is my Spa 2 speed pump not working?
II have a 2002 Optima spa. Several months ago the button on the top-side control panel for the 2 speed pump (#1) stopped working. There’s a second, smaller control panel on the opposite side of the tub which also will not work. But when the preset filter cycles occur the pump will come on and the icon comes on on the display.
What is the National Electrical Code for Sweetwater?
7)ELECTRICAL SUPPLY:The electrical supply for this product must include a suitably rated switch or circuit breaker to open all ungrounded supply conductors to comply with section 422-20 of the National Electrical Code, ANSI/NFPA 70.
When did Sundance Spas start making spa parts?
✔ Trusted Sundance® Spas Parts Experts Since 1994. Thousands of Sundance® Spas OEM factory parts in stock. Served over 200,000 happy customers. Sundance spas parts in stock.
