Is the Potterton Suprima boiler still a good boiler?
This used to make the boiler go into lockout. Everything needed comes in the box. All in all the Potterton suprima was and still is a good boiler compared to today’s condensing boiler. Potterton suprima were a very good boiler in their time, they were small and compact and would fit nicely inside a kitchen cupboard.
Are there any problems with the Potterton Suprima?
They came in many heat output sizes from 30,000 BTUs right up to 120000 BTUs and all in the same size case. The 120s were recalled a few times due to problems and eventually withdrawn, but all in all, they were a good boiler. The Potterton suprima had its faults though and one of them was the PCB or otherwise known as the printed circuit board.
Are there any problems with the Potterton 120?
The 120s were recalled a few times due to problems and eventually withdrawn, but all in all, they were a good boiler. The Potterton suprima had its faults though and one of them was the PCB or otherwise known as the printed circuit board.
How to reset the led on a Suprima boiler?
Press the reset button for a minimum of 1 and a maximum of 10 seconds (Do Not use excessive pressure), the LED will stop flashing and the boiler will attempt to re-light. Warning: If the LED is flashing Red rapidly the control is in remote diagnostic mode. The boiler will not operate in this mode and will need to be reset again.
This used to make the boiler go into lockout. Everything needed comes in the box. All in all the Potterton suprima was and still is a good boiler compared to today’s condensing boiler. Potterton suprima were a very good boiler in their time, they were small and compact and would fit nicely inside a kitchen cupboard.
They came in many heat output sizes from 30,000 BTUs right up to 120000 BTUs and all in the same size case. The 120s were recalled a few times due to problems and eventually withdrawn, but all in all, they were a good boiler. The Potterton suprima had its faults though and one of them was the PCB or otherwise known as the printed circuit board.
How big is the Potterton Suprima 100 ml injector?
Output 11.0 14.7 18.3 22.0 25.6 29.3 35.9 37 500 50 000 62 500 75 000 87 500 100 000 122 500 in wg 3.70 4.50 4.10 3.70 5.35 5.56 5.54 m³/h 1.05 1.40 1.75 2.10 2.45 2.80 3.42 ft³/h 37.1 49.3 61.8 74.2 86.4 98.7 120.9 Injector Size mm dia. 2.8 3.1 3.5 3.9 3.9 4.1 3.2 30 40 50 60 70 80 100 mbar 9.3 11.2 10.3 9.2 13.4 13.9 13.6
Where to find boiler serial number on Suprima 30-80?
The boiler model and serial number are given on the boiler data label which is located on the right hand side of the chassis and visible after opening the controls door. 3.
