Is the Goldline Aqua rite salt chlorinator still working?
The unit is actually a re-branded Goldline Controls “Aqua Rite” unit and seemingly has ceased working. I have weekly pool service and the unit has been cleaned several times, the las by me. It’s clean as a whistle and the salt reading is just about 2600.
What should the salt level be on my chlorine generator?
Your chlorine generator is still producing chlorine at the moment, which is a good thing. This is more of an indicator light than anything else. The salt level is 2300 ppm or less and no chlorine is generating. Step 1: Check your system to confirm that you have programmed the correct cell size.
Why is my Aqua rite pool not generating chlorine?
The Aqua Rite has sensed a no flow condition and has stopped generating chlorine. unit and that the wire is not cut or damaged. Make sure you have at least 12″ of straight pipe before the flow switch. If there is adequate flow and the LED is still on, check that
What causes bubbles in a Goldline salt chlorinator?
First off never trust any of the chemical readings these things spit out. The largest problems are caused from the cells not being cleaned. Remove the cell and soak for a couple minutes in a 20-30% acid water solution but no longer or you can damage the cell. You should see bubbles as soon as you put the cell in the acid water.
How often does a Goldline salt chlorinator make chlorine?
If yours is on a 30 minute cycle and your dial is set to 50% then the unit is generating chlorine for 15 minutes every 30 minutes. If it is set to 10% then your are generating chlorine 3 minutes every 30 minutes. The dial does not control how much chlorine is made but how long chlorine is made.
How to troubleshoot an aqua rite chlorine generator?
1 Press the featured diagnostics button five to show an instant salt level 2 Relax and allow the number to settle 3 Cycle slide prime switch from the auto chlorinate. 4 Switch off the unit to reset and then turn it back to auto 5 Wait for like five to seconds for the relay to click.
What happens if you run the chloriine generator at 60%?
Failure to do so will require you to run the chloriine Generator at a higher setting. If you run your generator @ 60% this means your generator is on 60% of the time if you put in the stabilizer and are able to cut your generator to 30% you just doubled your cell life !
Why is my salt chlorinator cell not working?
This is one handy little unit that is responsible for all the benefits of the system that allow us to enjoy clean chlorinated water without the pungent smell and irritating effects of chlorine itself. So what is it that causes the salt chlorinator cell to stop working?
