Is it possible to install new piping in concrete floor?
Yes, you can run water pipes in a concrete floor. They can also run under sidewalks, stoops, patios and decks.
How do you cut a small channel in concrete?
If you need to cut a shallow channel into a concrete floor to accommodate plumbing, electrical or another purpose, the quickest and easiest way is with a diamond-blade wet concrete/asphalt saw, which you can rent from many tool rental centers.
How hard is it to add a bathroom to a house on a slab?
In order to add a bathroom to a house on a concrete slab, you will need to locate the existing water supply and waste lines. Next, cut and remove the portion of the slab necessary to install the plumbing supply and drain lines, then repour new concrete over the new plumbing and make the floors as level as possible.
How do you put a P trap on a cement floor?
Attach a 2-inch PVC pipe to the horizontal opening on the P-trap. The pipe runs on top of the cement floor until it reaches the floor drain. Whenever you attach PVC fittings, use PVC cleaner and PVC glue as recommended on the packages. Slope the drainpipe by adjusting the level of the P-trap.
How tall does a P trap need to be on a shower floor?
This means that if the floor drain is 4 feet away from the shower drain, the end of the pipe where it meets the floor drain must be 1 inch lower than where the pipe connects to the P-trap. Since you can’t lower the floor, you must adjust the height of the P-trap.
How much does it cost to install a floor trap?
You can also get troughs that you insert your own tiles in so it just looks like two slots in the floor) only costs around $45, a chrome plated brass waste costs about $10, or if you don’t care too much about peeling chrome, then you could get a cheap and nasty chrome plated plastic waste for a couple of bucks (not worth the savings I reckon.
Can a drain line be cut through a concrete floor?
Cutting through a concrete floor should be a last resort. In the case of a broken drainpipe, it’s probably unavoidable. If you’re building an addition onto your home, however, you might be able to run the drain line from the addition around the outside of your foundation and tie into the main drain line in the yard. Quasius Equipment.:
Is it possible to install a floor trap in existing concrete slab?
The alternative of cutting a slot, putting the dry waste below, dowelling the slab and replacing the section would be better I reckon, but it would still crack there if it wanted to go anywhere. Ripping it all up and pouring a new slab is the perfect, but expensive solution of course.
What’s the best time to install a floor trap?
Of course this is also an aesthetic consideration since the bottom course of tiles can easily be cut to a fall. Recommended fall is between 1:80 > 1:60 (for showers), but I’ve seen floors with much less fall than this.
You can also get troughs that you insert your own tiles in so it just looks like two slots in the floor) only costs around $45, a chrome plated brass waste costs about $10, or if you don’t care too much about peeling chrome, then you could get a cheap and nasty chrome plated plastic waste for a couple of bucks (not worth the savings I reckon.
How to cut a 12 inch strip of concrete?
Snap two chalk lines on either side to form a 12-inch strip. Set the diamond blade on the concrete wet saw to a depth of 4 1/2 inches and cut along both chalk lines. This is noisy and can be time consuming, depending on the amount of steel reinforcement in the concrete.
