Is it hard to move a toilet drain?
Moving a toilet is not so much about moving the actual fixture—in fact, installing a toilet is a simple job that takes less than an hour—as it is about moving the drainage and the water supply plumbing to the new location. Once all of the plumbing is in place, installing the toilet is a relatively easy task.
How to relocate a drain from a toilet?
How to Relocate a Toilet Drain 1 Remove the old toilet by loosening the mounting bolts on the base of the toilet with a wrench. 2 Cut the drain pipe below the toilet flange with a hack saw and pull the flange off the floor. 3 Locate the new drain. 4 Install the new flange by setting it in the new drain hole.
What’s the best way to install a new toilet?
Glue a 90-degree toilet bend onto the end of the new drain pipe, then glue a 6-inch length of pipe into the upward-facing socket, extending up through the floor. Continue the previous water supply line with a single run of PEX pipe through the joists.
How big is a toilet drain pipe in inches?
The following diagram lays out the different terms that are used in the calculator: First, figure out the diameter of the pipe you are working with. For household sinks, the drain pipe diameter is often either 1.5″ or 2″. Toilet waste lines are often 3″ or 4″.
What kind of pipes do you need to move a toilet?
A relocated supply line might even tap into the existing toilet supply line and send it to the new location. Bendable plastic PEX pipes make this job easier for do-it-yourselfers than professional plumbers’ method of sweating copper pipes. Also, because water supply pipes are pressurized, there are no drainage issues.
Can a toilet be moved away from a drain line?
Toilets, sinks, and showers will always require pipes that wind through the house to connect to vent, water, and drain lines. The farther away you move these fixtures from those lines, the more complicated it gets and the longer it will take.
How can I move a toilet sewer drain in a concrete floor?
If you shove something down the pipe to block the gasses, make sure it does not go down the pipe. Also try to keep debris out of your drain. You don’t want to clog it up. You can use diamond tools to cut your way through the concrete.
A relocated supply line might even tap into the existing toilet supply line and send it to the new location. Bendable plastic PEX pipes make this job easier for do-it-yourselfers than professional plumbers’ method of sweating copper pipes. Also, because water supply pipes are pressurized, there are no drainage issues.
Where do you put the drain on a toilet?
The center of the drain is placed 12 inches from the back wall, and 15 inches or more from the closest side wall for standard toilets. If there is tile on the floor, remove with a hammer and chisel. Set a new flange in the new drain location.
