Is 30 inches enough space for a toilet?
Toilets and Bidets Most codes require at least 15 inches (measured from the center of the toilet) from any side wall or obstruction and not closer than 30 inches center to center to any other sanitary fixture. There should be at least 24 inches of clear space in front of a toilet or bidet.
Are high efficiency toilets worth it?
Installing a high-efficiency toilet can save an average family around $100 a year and about $2000 over the toilet’s lifespan. If your toilet was made in 1992 or before, you’re using 5-7 gallons per flush. That translates to anywhere between 9,000-13,000 gallons of water a year.
What do you need to install a toilet?
Every toilet is a little bit different, but you will probably need to install the “tank to bowl” gasket and insert the tank bolts and washers from inside the tank. Align your tank bolts with the holes in on the toilet bowl and lower your tank into position. Then secure it by tightening the bolts.
How big of a space do I need for a toilet?
Planning the Layout. The International Residential Code, which many communities follow, has clearance requirements that will determine how you lay out the space and where you install the rough-in plumbing. The finished toilet must have at least 21 inches of clearance in front of it and 15 inches from the center of the bowl to a wall on either side.
Where do you put the toilet on the wall?
The Distance To Set The Toilet Flange From The Back Wall. You’ll want to set the center of the water closet flange 12 inches from the finished back wall. Don’t measure from the base molding! Take this measurement from the finished wall. Now, if you’re measuring from stud walls, add in the thickness of your wall.
How do you install a toilet seat at Home Depot?
Feed the bolts through the holes in each hinge and the toilet bowl, with the head of the bolt on top. Attach the nuts to the other end of the bolts and tighten clockwise by hand and then with the wrench to insure a firm connection. If your hardware includes a pair of washers, put them on the bolts before the nuts.
