Is 102 too hot for hot tub?
Hot tub temperatures are a matter of personal preference. But the maximum safe temperature is 104° F (40°C). Many prefer temperatures between 100-102° F (37.7°C to 38.8°C).
Why does my hot tub say ICE?
When filling* your hot tub in cold conditions a warning message ‘IC’ or ‘ICE’ may appear. This is to inform you that the water temperature is below 7.2°C (45°F) and open to the risk of freezing.
What should I do if my spa water is 107°F?
One of the sensors has detected that the spa water is 110°F. Remove spa cover and let the water cool down. At 107°F the spa should reset. If spa doesn’t reset there is an issue with sensors or PC board. Find replacement PC board. Potential freeze conditions.
When does potential freeze occur in a spa?
Potential freeze condition detected and the System activates the heater and jets pump # 1 for protection. It happens when the spa water is more than 19.4°F (-7°C) colder than temperature set points. The system stays in this mode until water temps rise to 59°F (15°C) below the set temperature. No corrective action needed. Stands for Flow Switch.
What are the error codes for Master Spa?
Please note that the Balboa Error Codes cover all circuit board manufactured by Balboa including Cal Spa, Marquis Spa, Master Spa and many others. Gecko Error Codes also cover any control box manufactured by Gecko. Overheat. Spa has shut down. One sensor has detected 118º F at heater. Overheat. Spa has shut down. One sensor has detected 110º F.
What should the temperature be in a 10 degree hot water system?
The temperatures throughout a system with a 10 degree system temperature differential design should be as follows: 1. Hot water storage temperature in water heater (WH) = 150°F. 2. Hot water distribution temperature at master mixing valve (MV) outlet = 134°F. 3. Minimum Hot water return temp. at HWR conn.
One of the sensors has detected that the spa water is 110°F. Remove spa cover and let the water cool down. At 107°F the spa should reset. If spa doesn’t reset there is an issue with sensors or PC board. Find replacement PC board. Potential freeze conditions.
Which is the correct error code for spa?
(Displays when first powered up after refill). Spa operating in Standard Mode. Spa operating in Economy Mode. Safety Suction, Spa is shut down. Spa operating in Standard-in-Economy Mode. Overheat Protection (Heater is deactivated, pumps low speed is activated). Spa water is more than 20° F cooler than the temperature set point.
Potential freeze condition detected and the System activates the heater and jets pump # 1 for protection. It happens when the spa water is more than 19.4°F (-7°C) colder than temperature set points. The system stays in this mode until water temps rise to 59°F (15°C) below the set temperature. No corrective action needed. Stands for Flow Switch.
What is the error code on the Sundance Spa hot tub?
Sn1 Error Code: Heater is deactivated. High-limit sensor located in the heater drywell is nonfunctional. Sn3: Heater is deactivated. Main temperature sensor located in filter bucket is nonfunctional. 6. ILOC Error Code ILOC Error Code: Hot Tub is deactivated.
