How to turn off super chlorinate in ProLogic flow control?
To display the settings, press the Menu key until Settings Menu appears. Then press the > until Super Chlorinate appears . Use the (+) or (-) button to toggle between super chlorinate On or Off depending on preference. Then press the (>) one time to display chlorinator % options. Step 2
When was Aqua logic replaced by Pro Logic?
Aqua Logic was discontinued in 2008 by Goldline and replaced by the Pro Logic system. Buy the Chlorinator Pro CP-15, T Cell 15 Replacement here! Introduced in 2008, the Hayward Pro Logic salt chlorination system updated features from the recently discontinued Aqua Logic system.
Can a chlorinator pro be used as a salt cell?
Answer: The Chlorinator Pro CP-15 replacement salt cell is an exact size replacement for the AquaLogic salt system. No re-plumbing is necessary to use this generic salt cell. You can even use your own unions.
Why is the check system light off on Hayward Pro Logic?
When I go outside to the actual Pro Logic box, the check system light is off. Only the Aqua Pod is flashing “check system”. How do I figure out what the problem is? If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations.
What does the chlorinator off no flow message mean?
Within minutes, the “Chlorinator Off No-Flow” message went away, and the only messages remain are as follows: “Chlorinator Off – Low Temperature”, and “Check System – Low Salt”. I have the following Temperature readings: Pool Temp: 57 Degrees F, Cell Temp Sensor: 58 Degrees F, Water Sensor: 57 Degrees F, Air Sensor: 57 Degrees F.
To display the settings, press the Menu key until Settings Menu appears. Then press the > until Super Chlorinate appears . Use the (+) or (-) button to toggle between super chlorinate On or Off depending on preference. Then press the (>) one time to display chlorinator % options. Step 2
When to turn off the chlorinator in a pool?
Check System Light On: Cell Power Error Message Verify the system is configured for correct model cell. (Page 18). If the incorrect cell is chosen, the system will inaccurately interpret the salt level in the pool and the system may turn the chlorinator off. Maximum Current (Amps) before shutdown Page 10 3.
How to check the active salt reading on ProLogic?
The active salt readings \~instant salt appears in the Diagnostic Menu. Press the Menu button repeatedly, until the Diagnostic Menu appears. Then press (>) one time. If all zeros or if Chlorinator Off Percentage Met, press \~+ key. IF, after a short countdown delay, the display does not revert to zeros, refer to step 3.
