How to troubleshoot the xs-2000 Spa store?
1. Turn mains power OFF and wait approximately 20-30 minutes for element to cool and thermal cut-out device to reset. Then turn power back ON 2. Check spa water level (refill if necessary) 3. Remove filters and clean by soaking in hot water and filter degreasing solution
How to troubleshoot an internal controller fault in Spa?
Internal controller fault detected Hardware or software failure 1) Turn mains power OFF => wait 10 seconds => turn mains power ON 2) If error persists – contact your local spa reseller OR any SpaNETAuthorised Service Agent. (water & temperature) leave disconnected TM © SpaNET 2008.
What does an error message on a spa control mean?
The XS-2000 / 3000 / 4000 Series spa controls feature self diagnostics and scrolling error messages to quickly troubleshoot possible problems. Experiencing an error condition does not mean that your product is faulty. In fact most of the error conditions exist as a safety measure and to keep the spa control within its operating specifications.
Where are the pump buttons on the xs-2000?
ER8 – CTRL FAULT: An internal controller fault has been detected. Reset mains power. Contact your local dealer if problem persists. PUMP BUTTONS There are two pump buttons on the right hand side of the touch pad: Pump A and Pump B. The functions of the two buttons change depending on pump / controller configuration.
1. Turn mains power OFF and wait approximately 20-30 minutes for element to cool and thermal cut-out device to reset. Then turn power back ON 2. Check spa water level (refill if necessary) 3. Remove filters and clean by soaking in hot water and filter degreasing solution
Internal controller fault detected Hardware or software failure 1) Turn mains power OFF => wait 10 seconds => turn mains power ON 2) If error persists – contact your local spa reseller OR any SpaNETAuthorised Service Agent. (water & temperature) leave disconnected TM © SpaNET 2008.
What to do if your spa unit has er-3 error message?
Heater has been active and has had insufficient water flow over the element. Low or no water flow has caused the heater temperature to exceed its maximum limits and the spa control has shut down operation to prevent any damage to the heater unit Turn mains power OFF and wait 10-15 minutes for element to cool and thermal cut-out device to reset.
What are the error codes for Master Spa?
Please note that the Balboa Error Codes cover all circuit board manufactured by Balboa including Cal Spa, Marquis Spa, Master Spa and many others. Gecko Error Codes also cover any control box manufactured by Gecko. Overheat. Spa has shut down. One sensor has detected 118º F at heater. Overheat. Spa has shut down. One sensor has detected 110º F.
