How to troubleshoot Jandy aquapure error code 172?
Check salinity with Myron “L” meter calibrated for NaCl or test strips. Add salt as necessary Heated sensor element not heating. (Generates 172 code) Contact a pool professional. Flow sensor temperature sensor failure. (Generates 172 code – flow sensor service) Contact a pool professional.
Why is there an error code on my Jandy chlorine generator?
It becomes especially difficult if the product, like the Jandy AquaPure Chlorine Generator, only displays an error code, but not necessarily what the error code means nor solutions to the problem. If you purchased the unit a year ago, it’s quite possible you may have misplaced or thrown out the manual. How will you diagnose the issue then?
What to do if your Jandy pool sensor is not working?
Jandy recommends that you contact a pool professional for service if you encounter a Level 2 code. Heated sensor element not heating. (Generates 172 code) Contact a pool professional. Flow sensor temperature sensor failure. (Generates 172 code – flow sensor service)
What to do if you get a Jandy error code?
1. Recalibrate salt reading. 2. Backwash your filter if a DE filter is installed. 3. Partially drain your pool and dilute with fresh water until salinity level returns to 3.0. 1. Typically caused by low AC voltage from back board. Check the transformer and back board.
It becomes especially difficult if the product, like the Jandy AquaPure Chlorine Generator, only displays an error code, but not necessarily what the error code means nor solutions to the problem. If you purchased the unit a year ago, it’s quite possible you may have misplaced or thrown out the manual. How will you diagnose the issue then?
What is code 172 on Jandy aquapure error code?
Salinity sensor sees less than .2 GPL of salt. Either there’s no salt in the pool or sensor is air locked. Flow salinity sensor temperature probe error codes. 1.They all generates code 172- Flow sensor service is required. 2. Perform diagnostic test on board to ensure the board isn’t faulty. If not the board, the tri-sensor is the culprit. 3.
1. Recalibrate salt reading. 2. Backwash your filter if a DE filter is installed. 3. Partially drain your pool and dilute with fresh water until salinity level returns to 3.0. 1. Typically caused by low AC voltage from back board. Check the transformer and back board.
Why is the salinity invalid on Jandy aquapure?
Cell current is 85% lower than desired and cell voltage above 19V. Salinity invalid due to out of range measurements caused by front board error. Although the charts should help narrow down the root to the issue on your Jandy AquaPure unit, it may not completely answer all your questions or concerns.
Check salinity with Myron “L” meter calibrated for NaCl or test strips. Add salt as necessary Heated sensor element not heating. (Generates 172 code) Contact a pool professional. Flow sensor temperature sensor failure. (Generates 172 code – flow sensor service) Contact a pool professional.
What to do if your pool has a 170 code?
Contact a pool professional. Contact a pool professional. Measured significant cell current when SCRs were turned off. (Generates 170 code – front board service) Contact a pool professional. Contact a pool professional. Contact a pool professional. ORP unit or external controller has shut off chlorine production.
What to do if your service code is wrong on your pool?
Conclusion: While most service codes can be solved by the pool owner, not all are immediately fixable, and if this happens it’s important to contact a local service technician who can identify and correct the error to ensure safety and warranty compliance.
What is the error code for the salinity sensor?
Contact a pool professional. Salinity Sensor sees less than 0.2 gpl of salt, no salt in pool or sensor air locked. (Generates 175 code – flow sensor air lock) Contact a pool professional. Flow salinity sensor temperature probe error codes.
