How to troubleshoot a spa touch pad problem?
The first thing is to do is to identify the sympton from the list below: Spa Touch Pad / Topside Control Associated Problems: If the problem is not obvious, look on the topside control panel for diagnostic messages. If no messages are seen, run through all spa functions and note any inconsistent operation.
What to do if your hot tub is not responding?
If the spa does not respond, contact your dealer for service. Press the “Jets” button on your control panel. Check that all the slice valves are open. The pump (s) may need to be primed.
Why is my spa topide control panel not working?
But there are some ways to reduce the risk… read on. Bottom line is – it could be a bad spaside control panel, or it could be a bad spa control board, or a bad cable that runs between the control panel and the control board. Or it could be fuse on the circuit board or the transformer, not sending the correct power to the topside panel.
Why does my hot tub control panel keep blinking?
If there is any condensation, dry it off. A blinking red light on the control panel may indicate it needs to be reset. For most models, you will need to turn off the power to the spa for a minute or two and then turn it back on again. Turn on the lower amp breaker first if you have a hot tub powered by 240 volts.
How to troubleshoot a spa side control panel?
Spaside Control Panel Buttons Not Working Correctly 1 Check for moisture under glass or on contacts 2 Check cable for any rodent damage, crimping or melting 3 Clean plug-in cable connections at both ends 4 Membrane or touch pad buttons may be faulty 5 Inspect circuit board for damage and correct power output 6 Replace topside control
If the spa does not respond, contact your dealer for service. Press the “Jets” button on your control panel. Check that all the slice valves are open. The pump (s) may need to be primed.
What does blinking red light on hot tub control panel mean?
Blinking Red Light. A blinking red light on the control panel may indicate it needs to be reset. For most models you will turn off the power to the spa for a minute or two and then turn it back on. Turn on the lower amp breaker first if you have a hot tub powered by 240 volts.
When do I need to reset my hot tub control panel?
If your hot tub control panel isn’t working then when it can be really frustrating. Having said that, sometimes all you need to do is a simple reset on your hot tub control panel to clear the problem and to get it back into action.
