How to troubleshoot a Jandy aquapure power supply?
If salinity is low, more salt may need to be added. Clean the cell if it is dirty or clogged. Check that the unit is connected to a power supply and the pump is switched on. Fully insert into the connector the ribbon cable between front and back PC board. Properly connect the connector at the white plug between the transformer and back PC board.
What to do if your aquapure has water leak?
• Be sure that the cell positioned properly and the DC cord is connected properly to the cell. • Check the flow sensor cable and cell cable for damage (chewed on by an animal, weed-wacked, etc.). • Look for water leaks at the cell and flow sensor.
How do I Reset my aquapure flow sensor?
Connect it to the unit and place it in a bucket of the pool water to compare readings. Note-The unit must have the power turned off before either the old or new flow sensor can be installed. Each time a flow sensor is unplugged and plugged back in again the computer inside the unit must be reset by turning the power ‘off’ and then ‘on’.
What should the chlorine content be on a Jandy aquapure?
Chlorine stabilizer content should be 50 to 75 PPM. For every 50 pounds of salt, 1.25 pounds of stabilizer should be added. Increase the system’s daily operating time. Increase chlorine production by pressing the “chlorine production rate adjustment” button. Enable “boost” mode and run for 24 hours. Press the “test salinity” button.
What do you need to know about Jandy aquapure?
AquaPure is a salt chlorine generating system used to sanitize your pool, using a closed-loop water-softening system. As with any electronic and mechanical systems, problems can occur.
Connect it to the unit and place it in a bucket of the pool water to compare readings. Note-The unit must have the power turned off before either the old or new flow sensor can be installed. Each time a flow sensor is unplugged and plugged back in again the computer inside the unit must be reset by turning the power ‘off’ and then ‘on’.
• Be sure that the cell positioned properly and the DC cord is connected properly to the cell. • Check the flow sensor cable and cell cable for damage (chewed on by an animal, weed-wacked, etc.). • Look for water leaks at the cell and flow sensor.
What does an aquapure do in a pool?
AquaPure is a salt chlorine generating system used to sanitize your pool, using a closed-loop water-softening system.
How do you install a Jandy Pro remote?
1. Remove the new Handheld Remote from the packaging. 2. On the back of the Handheld Remote, loosen and remove the two (2) screws that secure the cover for the battery chamber (see Figure 1). Figure 1. Battery Installation on Handheld Remote Handheld Remote (Back View) Two (2) AA Batteries Battery Chamber Cover for Battery Chamber Screws
How to check the salinity of a Jandy pool?
•The system will display the salinity reading, press the up arrow to increase the reading and the down arrow to decrease the reading. •When the proper reading is reached press the “Temperature” button within 5 seconds to store it in memory. 15 Transformer Voltage on Rev. 2 backboard Reading the AC voltage between T.P.-
