How to start iaqualink in WiFi setup mode?
1 Wire iAquaLink™ to the AquaLink Automation system. 2 Start WiFi Setup Mode 1 2 4 Ensure all power to AquaLink is OFF, then remove the dead panel. Pass the iAquaLink cable through the low voltage raceway of the AquaLink. Reinstall the dead panel (and/or close doors if applicable) to ensure high-voltage areas are secured. Connect iAquaLink to the
How to add iaqualink to your swimming pool?
Attach the Web Connect Device as close to the home’s router as possible. Locate the WiFi/Wired switch and ensure it is in the WiFi position Mount the antenna at least 6 ft. (2m) high and 10 ft. (3m) from any electric motor, device, or metal object.
How do you connect an iaqualink antenna to a computer?
1. Remove the two (2) screws from the cover of the iAquaLink antenna. Remove the gasket and cover. 2. Locate the WiFi/Wired switch and ensure it is in the WiFi position. 3. Using a USB cable, connect the iAquaLink antenna to an Internet enabled computer. 4. Download the WiFi Set-up tool below and follow the directions.
What do you need to know about iaqualink 2.0?
With iAquaLink 2.0, Wi-Fi setup is done wirelessly using a smart device. You will need a smartphone or tablet to perform Wi-Fi setup using the Hotspot setup method (any iPhone, iPad, Android device, Windows Phone, or tablet will work).
How do I set up iaqualink on my phone?
After clearing the WiFi settings and with the Wired/WiFi switch set to WiFi, use a smartphone or WiFi enabled device to go to WiFi settings. Connect to the network labeled iAquaLink. iAquaLink will display the networks it detects, as well as signal strength. Select the network iAquaLink should use.
What do I need to install iaqualink in my Pool?
iAquaLink installation consists of wiring the iAquaLink Web Connect Device to the RS485 communication port on an AquaLink automation system. This must be done by a licensed electrician or a qualified pool professional. The device is weatherproof so it can be mounted in the best position for connection to the modem/router.
How do I connect my iaqualink J-box to my computer?
Locate the WiFi/Wired switch and ensure it is in the WiFi position. Using a USB cable, connect the iAquaLink J-Box to an internet enabled computer. Download the WiFi Set-up tool below and follow the directions.
How do I connect iaqualink to power center board?
Guide the connector and wire through to the rear of the power center board. Pull the connector between the PC board & the metal brace, and connect it to the red 4-pin socket as shown. Up to two devices can be connected to one 4-pin socket (two wires per hole). If more capacity is needed, a 6584 multiplex board can be installed.
