How to set Turbo cell size on Hayward Aqua rite?
How To Set Your Turbo Cell Size Slide your main switch to the AUTO position. Switch your cell type by cycling the main switch from AUTO to SUPER CHLORINATE and then back to AUTO. Push the diagnostic button until “T-XX” appears on the display.
What’s the T cell setting on Aqua rite chlorinator?
Over the years Hayward has updated the large PCB board behind the display panel. The revision starts with a lowercase “r” followed by 1.XX . See T-Cell Setting below for major differences between r1.40 and lower vs r1.50 and higher. 9. T-Cell Setting Appears only if Software revision is r1.50 or higher.
How long is the duty cycle for Aqua rite T cell 15?
For software revision 1.50 or higher the duty cycle is 180 minutes. Everything else involving output % and pump run time remains the same as well as voltage, amperage, and ISR. Save money with the CP-15 Replacement Cell for Aqua Rite T Cell 15.
What’s the replacement part number for Aqua rite XL?
Replacement turbo salt cell for the Goldline Aqua Rite salt chlorinator from Hayward, Hayward replacement part number T-CELL-15. An electronic chlorine generator for in-ground pools The Aqua Rite XL uses common salt (the same salt used in water conditioners) and converts it into “free” chlorine.
How to check salt level on Hayward Aqua rite Turbo cell?
Press the “right” button again until an “Instant Salt” option appears. Your final step will be to press the “+” button directly on your unit, which should display your pool’s true salt level.
What’s the best way to troubleshoot an aqua rite cell?
(GLX-CELLSTAND) Step 1: Use a water hose to dislodge small debris. Step 2: Use a non-metal (plastic or wood), non-abrasive tool to dislodge minor calcium buildup and small debris. Step 3: Use a solution of water and Muriatic acid. Stand the cell vertically in the solution. M’x 1 part acid to 4 parts water.
Where can I find the Aqua rite diagnostics manual?
Aqua Rite & Aqua Rite XL Diagnostics Manual AQUA RITE ELECTRONIC CHLORINE GENERÀTOR CELL Turbo Cell & Control Electronics Software Revision 1.50 O HAYWARD Copyright 2009 Hayward Industries Inc.
What should the salt level be in aqua rite pool?
The ideal salt level is between 2700-3400 ppm (parts per million) with 3200 ppm being optimal. If the level is low, determine the number of gallons in the pool and add salt according to the chart on page 4. A low salt level will reduce the efficiency of the Aqua Rite®and result in low chlorine production.
