How to reset my Rheem pool heater?

Reset the circuit breaker by turning the circuit breaker off and then back on. Wait five minutes for the Rheem pool heater to power back on and the “Power” light on the control panel to illuminate.

What kind of remote does Raypak pool heater use?

Any two-wire or three-wire remote can connect to the Raypak Digital and be integrated into the pool control system of your choice. The Raypak Digital has the best outdoor design in the market today. With over 50 years in designing and building gas heaters, Raypak has put all that experience into its newest heater design.

How to troubleshoot a Rheem pool heater with SNS?

Clean the water temperature sensor, which is on the filter pump, with a cloth slightly dampened with rubbing alcohol. Allow the sensor to air-dry. Reset the circuit breaker by turning the circuit breaker off and then back on. Wait five minutes for the Rheem pool heater to power back on and the “Power” light on the control panel to illuminate.

What does SNS mean on a pool heater?

The pool heat can be controlled from the digital control panel and an on-board diagnostic tool informs users if there is a problem with the heater by displaying an error code. The SNS error code indicates that one of the pool heater sensors is not working and some troubleshooting is necessary.

What does an error code on a Raypak heater mean?

No one likes to get an error code on any piece of technology, especially on a Raypak heater. It means something is wrong and needs to be addressed soon. The panic really doesn’t set in until you realize error code BD1 means absolutely nothing to you. Error codes are both curses and blessings.

What kind of pool heater does Raypak use?

PERFECTLY RELAXING. Raypak’s Pool & Spa Heaters are designed for high efficiency – and low stress.

Where is the sensor on a raypac pool heater?

After the four screws, the top of the bezel should rotate down toward you hinging at the bottom. You may have to give it a gentle tug. That is where the sensor plugs into the board. The sensor itself is located at the water connection side of the heater.

How can I Make my raypac 266 heater more sensitive?

There is a thumb wheel adjustment on the pressure/flow sensor that you can turn to make it more or less sensitive to system pressure changes. There is a thumb wheel adjustment on the pressure/flow sensor that you can turn to make it more or less sensitive to system pressure changes.