How to reset AquaLink remote?

How do I Reset a Jandy AquaLink System?

Press the “Menu” button.
Scroll to and highlight “System Setup” using the arrow keys. Press “Enter.”
Scroll to highlight “Clear Memory,” then press “Enter.” You have now reset your AquaLink system.

Why does my Jandy PDA model 8265 not work?

My jandy PDA model 8265 is stuck opn waiting. I’ve tried changing the RF Channel but no response from the Jbox … read more I have a Jady Aqualink RS PDA. I’ve had it years now working I have a Jady Aqualink RS PDA. I’ve had it for 3 years now working fine. It turned on the hot tub and then showed handheld:3.0 Battery:ok RF … read more

Why is my Jandy PDA stuck on waiting?

Cycle the computer My Jandy PDA is also stuck on waiting. Cycle the computer power breaker and it connects as usual. Power PDA off and on again, stuck in waiting. … read more

Is the Jandy Aqualink control panel lit up?

I have a Jandy Aqualink system. The control panel is 99% lit up and frozen, with the exception of the pool mode light which is not on. The buttons … read more I have a jandy power center PCB 8124a. It will not power the i have a jandy power center PCB 8124a. It will not power the filter pump module … read more

How does a Jandy work with a Zodiac heater?

HI, I have a new jandy pda. I have a stand alone zodiac heater. How do you connect the power to the heater so that the temperature sensor for the jandy controls the relay to shut down the heater. My h … read more

Cycle the computer My Jandy PDA is also stuck on waiting. Cycle the computer power breaker and it connects as usual. Power PDA off and on again, stuck in waiting. … read more

How much does it cost to fix a Jandy PDA?

With new PDAs going for $300 I figured I had nothing to lose by trying to fix the old one. The results were better than expected, and the PDA now works as good as new. Total cost was about $15 which is a heck of lot less than a new PDA.

How can I fix the keypad on my Jandy PDA?

It also works on TV remotes, phones, calculators, computer keyboards – any device that uses rubber membrane technology. To use “Keypad Fix” just follow the directions. Clean the pads (circled in red) gently with isopropyl alcohol on a swab and let dry. Stir “Keypad Fix” well, then apply a thin coat with a swab.