How to repair an automatic step-RV with Tito?
1 Disconnect the main connector to step and controller unit 2 Remove the bolts securing the controller board (leave wires connected) 3 Replace the controller board with the new one and secure it with the bolts 4 Move each wire from the old controller to the new controller 5 Reconnect the main plug to the step 6 Verify proper step operation
When does a step stop turning the motor?
It will stop turning when it can’t move anymore (i.e. step is fully extended or retracted). The gear linkage has a metal arm that moves the step in and out. When the motor moves the gear, the gear moves the metal arm either in or out which, in turn, moves the step.
What do you need to know about Fleetwood RV parts?
Peace of mind that you have the right part for your specific make, model and repair. A knowledgeable team that can help you troubleshoot repairs and find exactly what you need. Genuine, factory-certified, manufacturer-engineered parts that are built to perform.
Where is the motor on a Kwikee step?
You can find the manual for your Kwikee step model here. The motor is mounted on top of the gear linkage with three bolts. It drives the gear linkage in forward or reverse when activated by the controller. It will stop turning when it can’t move anymore (i.e. step is fully extended or retracted).
1 Disconnect the main connector to step and controller unit 2 Remove the bolts securing the controller board (leave wires connected) 3 Replace the controller board with the new one and secure it with the bolts 4 Move each wire from the old controller to the new controller 5 Reconnect the main plug to the step 6 Verify proper step operation
It will stop turning when it can’t move anymore (i.e. step is fully extended or retracted). The gear linkage has a metal arm that moves the step in and out. When the motor moves the gear, the gear moves the metal arm either in or out which, in turn, moves the step.
Peace of mind that you have the right part for your specific make, model and repair. A knowledgeable team that can help you troubleshoot repairs and find exactly what you need. Genuine, factory-certified, manufacturer-engineered parts that are built to perform.
What to do if your steps have a bad motor?
If you get a motor with the wrong number of teeth, don’t panic. You can usually move the correct gears from the old motor to the new one. The control unit for the steps is a solid-state unit that has no moving parts and very seldom fails. Almost all erratic step behavior is caused by a bad motor.
