How to remove a Thetford Aqua Magic toilet?
Disconnect the fresh water supply line and lift toilet straight up. For Aqua-Magic IV, disconnect the water supply line from the water valve located on the rear of the toilet. Remove the nuts from the closet flange bolts located on each side of the toilet. Carefully lift and remove the toilet from the closet flange.
How to identify my thetford toilet?
Using the data sticker to identify your Thetford toilet model. If you are not sure which model toilet you have, you will find a data sticker attached to the base of the toilet beneath the waste holding tank. The model number will be printed at the beginning above the barcode – as shown below.
How do you fix a leaking RV toilet?
How to Fix an RV Toilet Leaking Around the Base
- Buy a new flange seal that matches your toilet model.
- Shut off the water to the toilet.
- Flush the toilet to drain it.
- Remove the toilet from the floor.
- Replace the seal.
- Put the toilet back and turn the water back on.
Why is there no water in my RV toilet?
Most likely, a broken slide valve or blockage is to blame, but in both cases, the pressure isn’t the actual culprit. Instead, it’s some other issue that is causing the pressure to not do its job. If there is no water pressure from any faucet in your RV, the pressurized mechanism may be broken.
How do I stop my RV toilet from leaking?
Is it ok to flush toilet paper in a septic tank?
The best thing to do for your septic system is to be sure not to flush anything other than human waste and toilet paper, preferably single-ply toilet paper. It is not good for your septic system to flush anything other than human waste and toilet paper because it does not break down in the septic system correctly.
How to remove an Aqua Magic SL toilet?
Flush the toilet to empty water from the bowl and remove remaining water pressure. Disconnect the water line from the water valve/elbow. Loosen the two nuts at the base of the toilet. Lift the toilet from the floor. Remove the closet flange seal.
Where are the bolts on an Aqua Magic Galaxy toilet?
The Aqua-Magic Galaxy and Starlite models are mounted to the floor with two closet bolts and nuts. One is located behind the foot pedal and is easily accessed by depressing the foot pedal. Remove the 1/2 inch nut. The other closet bolt is located behind the toilet.
Can a vacuum breaker be replaced on an Aqua Magic toilet?
Generally, the cause is the toilet’s Vacuum Breaker. For Aqua-Magic Aurora, Galaxy and Starlite, repair or replace the Vacuum Breaker. For Aqua-Magic IV, replace the Water Valve. What does the Vacuum Breaker do?
Do you need to replace toilet on Aqua Magic Aurora?
A special tool to clean the groove is available from Thetford and various dealerships. If this doesn’t correct the problem on the Aqua-Magic Aurora, Galaxy and Starlite models, you may need to repair or replace the Flushing Mechanism or, depending on its age, replace the toilet.
