How to lubricate the Wingard Batwing Sensar TV antenna on?

I will demonstrate how to disassemble, clean and lubricate the Winegard Batwing Sensar extendable TV antenna on your RV. This will prevent water from leaking inside your RV as well as provide ease to raising and lowering your antenna. This video is for demonstration purposes only.

What kind of antenna does motorized Sensar have?

Model MA1000W has white antenna head and white turret. Unit packed as follows: Motorized Mount with booms attached. Antenna Head Hardware Bag Instructions Antenna Power Supply Coax Cable Power Cable Control Cable Read Installation Instructions before installing unit. Read Motorized Sensar Operation before operating unit.

How big is a Sensar motor control panel?

Current draw of electronics when Power Light is on — Nominal 46mA, 70mA Max. Current draw of electronics when Power Light is on and motor running — 3 amp Max. Control Panel Size: 4.5 x 4.5 Control Panel Weight: .5 lbs. Warning Device – .2 amps (not included)

What’s the operating voltage of a Sensar motor?

Operating Voltage Nominal 12VDC – Operating range 9.5 VDC to 15.5 VDC Current draw of electronics when Power Light is off — Nominal 500uA, 1.5mA Max. Current draw of electronics when Power Light is on — Nominal 46mA, 70mA Max. Current draw of electronics when Power Light is on and motor running — 3 amp Max.

Can you use a Winegard satellite TV antenna?

Winegard satellite TV antennas are compatible with DIRECTV, DISH, Bell TV, and Shaw Direct. Portable satellite antennas offer easy setup and storage. Roof mounted antennas permanently mount to the roof of your RV allowing for quicker setup and no storage space required.

How big of a hole to drill for Sensar antenna?

Drill hole 1-1/2″ to 3″ Diameter for Wires on Roof FIGURE 2B Coax Connector c STEP 3: In traced triangular area for cables, drill a hole (1.5″ to 3″ Dia.) in roof. Route cables through roof to where you have selected control panel to be mounted.