How to light a pilot on a gas water heater?
The first thing you will want to do turn the temperature setting to its lowest position. Then turn the gas vavle to ‘Off’. You should wait about ten minutes before you do anything else. There may be some lingering gas that you want to dissipate before you try to light the pilot. The next step is to remove the outer cover from the burner assembly.
How do you adjust a gas valve on a water heater?
It is important that the gas valve matches the pressure rating of the water heater along with the type of gas such as natural gas or propane. Turn the screw clockwise to raise the pressure of the water heater. Turn the screw counterclockwise to lower the pressure of the water tank.
How do you lower pilot light on Honeywell gas valve?
Not all Honeywell gas valves have this option. Use the screwdriver to turn the screw clockwise to lower the pilot light. This moves the screw into the gas valve, lowering the flame. Turning this screw too much will extinguish the pilot light.
How to adjust the temperature of a pilot light?
How to Adjust a Pilot Light 1 Operation of the Thermocouple. The thermocouple is a heat-sensitive electronic device that generates a small electrical signal when it reaches a certain temperature. 2 Adjusting the Thermocouple. 3 Adjusting the Pilot Flame. 4 Regulating Air Flow. …
How do you relight a pilot light on a water heater?
Relight the pilot light. Turn the control valve to “on”. When the gas burner comes on, use a 50/50 dish soap/water mix to test the screw joints for air bubbles that indicate leaks. Note: When relit, the water heater pilot light flame should wrap around the thermocouple bulb.
How do you change the pilot on a DSi water heater?
Turn gas cock counterclockwise to “pilot” position, press reset button and light pilot, hold down until pilot remains lit. The DSI water heater must have an acceptable DC-voltage range to function and adjust at regulator. 2) Clogged pilot orifice – clean or replace.
How to Adjust a Pilot Light 1 Operation of the Thermocouple. The thermocouple is a heat-sensitive electronic device that generates a small electrical signal when it reaches a certain temperature. 2 Adjusting the Thermocouple. 3 Adjusting the Pilot Flame. 4 Regulating Air Flow.
What to do when pilot goes out on gas heater?
You can also poke the aperture of the pilot tube with a needle. If the pilot on your gas appliance goes out frequently, there may be a draft in the room. Heater gas controls are frequently at floor level, and air can sweep in under nearby doors and blow out the pilot.
