How to install Pentair IntelliFlo vs-3050 user guide?

IntelliFlo VS-3050 Installation and User’s Guide IMPORTANT SAFETY PRECAUTIONS Before installing this product, read and follow all warning notices and instructions in this Guide. Failure to follow warnings and instructions can result in severe injury, death, or property damage. Call (800) 831-7133 for additional free copies of these instructions.

Is the Pentair IntelliFlo pump a registered trademark?

Trademarks and disclaimers: IntelliComm®, EasyTouch®, IntelliTouch , SunTouch , IntelliFlo and Pentair Water Pool and Spa®are trademarks and/or registered trademarks of Pentair Water Pool and Spa, Inc. and/or its affiliated companies in the United States and/or other counties.

What’s the difference between IntelliFlo and variable speed pump?

IntelliFlo® VS-3050 Variable Speed Programmable Pump (Compatible with IntelliComm® communication center and EasyTouch®, IntelliTouch®and SunTouch™control systems) AUTO HEATER SPA 100 °F/95°F AIR 70°F MON 09:30 AM © 2009 Pentair Water Pool and Spa, Inc. All rights reserved This document is subject to change without notice

How much pressure can an intellipro pump generate?

The IntelliPro pump is capable of generating systems pressures up to 50 psi. Installers must ensure that all system components are rated to withstand at least 50 psi. Over pressurizing the system can result in catastrophic component failure or property damage.

How do I connect my IntelliFlo pump to my Aqualink?

To connect the Intelliflo to the Aqualink, use the comm cable that came with the pump. It plugs directly into the connector on the side of the pump. Inside the Aqualink cabinet, connect the yellow wire to Pin 2 on one of the red communication connectors at the top left of the board.

Can a Jandy VF pump be connected to an IntelliFlo?

While that certainly is neat, it all goes out the window when you connect the Jandy to the Intelliflo. On the Jandy iAqualink system, when you set up the VSP (variable speed pump), you’ll notice you set the speed, not the actual flow rate or gallons and desired turnovers.

How many Watts Does a Pentair IntelliFlo VF pump use?

I’ve gone from a Hayward Super II 2hp single speed pump, sucking about 2400 watts, to a Pentair Intelliflo VF which, at 35 gallons per minute (GPM), is running about 600 watts. I will divulge that I purchased the Intelliflo at PoolSupplyWorld.com for about $1130.