How to check spa panel messages in Windows 10?
Common Spa Panel Messages. 1 1. Turn OFF the Power to the System and Turn it back ON again to put System into Priming Mode. 2 2. Press any “Cool”, “Warm”, or “Temp” Button to Exit Priming Mode. 3 3. After about 45 Seconds, Check for Error Messages on the Topside Panel Display. If there is No Error Message, Select “No Error Message” Below. If …
What to do when your spa panel is not working?
Contact your Dealer or Service Organization to check the Switch Numbers or Setting Values Displayed, and Correct as Necessary to Match the Equipment in the Spa System, or Continue for a Detailed Test Procedure. 1. Turn OFF the Power to the System and Turn it back ON again to put System into Priming Mode.
How to check spa panel messages on Balboa direct?
1. Turn OFF the Power to the System and Turn it back ON again to put System into Priming Mode. 2. After about 45 Seconds, Check for Error Messages on the Topside Panel Display. If there is No Error Message, Select “No Error Message” Below. If there is Now an Error Message, select Message Other than CrC or CHKSUM FAIL below.
When does the spa go to sleep mode?
The spa will automatically revert to Economy mode after one hour (or instantly if you press ‘Mode/Prog’). Sleep Mode heats the spa to within 20° of the temperature set-point, but only during filtration cycles. The Sleep icon will be displayed unless the mode is changed. Additional Control Panels – supplied on some spa models
How do you remove a spa control panel?
Slide the spatula around in order to break the silicone mounting seal of the spa control panel. If this does not easily occur, you can use a large flathead screwdriver. To prevent scratches or cracks, use a towel between the screwdriver and the silicone.
Is the spa topside control panel returnable?
Since spaside panels are not returnable, this entails some risk on the spa owner. But there are some ways to reduce the risk… read on. Bottom line is – it could be a bad spaside control panel, or it could be a bad spa control board, or a bad cable that runs between the control panel and the control board.
Common Spa Panel Messages. 1 1. Turn OFF the Power to the System and Turn it back ON again to put System into Priming Mode. 2 2. Press any “Cool”, “Warm”, or “Temp” Button to Exit Priming Mode. 3 3. After about 45 Seconds, Check for Error Messages on the Topside Panel Display. If there is No Error Message, Select “No Error Message” Below. If
Where can I find the vortex spa control panel?
Information on adjusting filter duration can be found in the control panel’s instruction manual. 2. The length of time required to heat your spa to the desired water temperature will vary, depending on the air temperature, season, and wind velocity. Therefore, this is something each owner must adjust to their desired liking.
