How to check for no flow on Jandy aquapure 1400?
Test the temp of the pool then compare it to the read out from the a/p. Also take a water sample to a pool place and have them test it for salinity (not using test strips) and compare that to the a/p readings. Finally, camp out in front of the unit and wait to see if it gives you a three number fault code. If you call Jandy, dont expect much help.
Why does my Jandy pool have no flow?
An old problem has come back again. No Flow with the Jandy Aquapure Handheld and the LCD panel one green light on and no error codes which I used to get in the past. The sensor is only about a year and a half old. The Chlorine cell is about 4 years old.
What should I expect from Jandy pool Tech?
If you call Jandy, dont expect much help. They will be real quick to give you pool repair tech phone #’s and that’s about it. Also, they discontinued the cell that they had out a few years ago. They came out with a new design that retrofits.
What is the temperature code on the Jandy flow sensor?
Now getting the magic 172/185 code “flow salinity sensor temperature probe error codes”. I’m on my 15th minute of hold for Jandy tech support (once again) to see if there are further tests I can run or if the flow sensor is defective as suggested in the manual.
Test the temp of the pool then compare it to the read out from the a/p. Also take a water sample to a pool place and have them test it for salinity (not using test strips) and compare that to the a/p readings. Finally, camp out in front of the unit and wait to see if it gives you a three number fault code. If you call Jandy, dont expect much help.
How to change a Jandy aquapure front board power supply?
Flow salinity sensor temperature probe error codes. 1.They all generates code 172- Flow sensor service is required. 2. Perform diagnostic test on board to ensure the board isn’t faulty. If not the board, the tri-sensor is the culprit. 3. How To Change a Jandy AquaPure Tri-Sensor Front board power supply is either too low or too high. 1.
What is code 172 on Jandy aquapure error code?
Salinity sensor sees less than .2 GPL of salt. Either there’s no salt in the pool or sensor is air locked. Flow salinity sensor temperature probe error codes. 1.They all generates code 172- Flow sensor service is required. 2. Perform diagnostic test on board to ensure the board isn’t faulty. If not the board, the tri-sensor is the culprit. 3.
What to do if your Jandy pool sensor is not working?
Jandy recommends that you contact a pool professional for service if you encounter a Level 2 code. Heated sensor element not heating. (Generates 172 code) Contact a pool professional. Flow sensor temperature sensor failure. (Generates 172 code – flow sensor service)
