How often do I add salt to my pool?

There is no set timeframe of when you need to add salt to your pool. Because salt does not dissipate from your water, the only time you would add salt to your pool is when you add fresh water or after heavy rain that dilutes salinity levels.

How long does it take for salt to dissolve in pool?

about 24 hours
When you add salt, DO NOT pour it directly into the skimmer. For best results empty the required salt into the shallow end of the pool and let it dissolve and circulate through the main drain. The salt may take about 24 hours to dissolve completely.

What to do if your salt level is above 3200ppm?

If salt level is above the range, partially drain the pool and/or spa and refill with fresh water to achieve a salt level of 3200ppm, refer to page 9, Step D. If the salt level is not high, verify the correct cell is being used then reset (follow steps for How to Reset Average Salt Levels above)

What should the low salt reading be in a pool?

An electronic tester measures conductivity (which is dependent on the total number of each type of ion) and converts that into a salt reading. The cell is calibrated at 77 o F. For every 5 degrees below that, the salt will read 200 ppm low. At 64 o F, the salt will read about 520 ppm low.

When do I reset the average salt level?

How to Reset Average Salt Levels. The Average Salt level needs to be reset for start up, when a board is replaced, when major adjustments are made to the pool water, and when a cell is replaced. Note: new boards will display a factory default of 2800ppm. Step 1: To reset, move the switch to ‘Off’ and then back to ‘Auto’.

When does the low salt warning light come on?

For every 5 degrees below that, the salt will read 200 ppm low. At 64 o F, the salt will read about 520 ppm low. Below 2,900 ppm, the low salt warning light will come on, but the cell will continue to work. Below 2,500 ppm, the cell will shut off.

Why do I get a zero reading on my salt level?

So if you are trying to test the salt level you may get a zero reading because of the Catch 22. So follow these steps to check the salt level: 1-Turn the percentage to 100%. 2-Slide the switch to off if it is currently in the Auto position. 3-Slide the switch back to Auto.

Why does the salt reading not match the strip?

The reading is also somewhat affected by the water temperature, generally reading a bit lower than actual when the water is cold. Depending on the time of day and when you looked at the reading relative to when you added the salt, it could do what you describe. Don’t expect the reading to exactly match a salt test strip.

Can you get a low reading on the salt level in your pool?

Your cell may have failed. As the Hayward / Goldline cells fail they will give you a false low reading of the salt level in your pool. NEVER ADD SALT BASED ON THE READING OF YOUR SALT GENERATOR! Always take you water to a professional swimming pool store and have it tested.