How much chlorine should be in a hot tub?
How Much Chlorine Should I Add to my hot tub? A chlorine level of between 3-5mg/l must be maintained in your hot tub at all times. The addition of chlorine will depend upon usage and bathing habits. It could be daily or every 2-3 days (for 1mg/l add 2g per 1000 litres).
What is the error code for hydrospares hot tub?
PSoH : Pressure switch open with high pump. ToE : Time out error. Rare system error. OH: water over 112° F. System will restart when temp. drops hot: water over 112° F. System will restart when temp. drops OH: Overheat 108° F, spa is deactivated.
What is the code for overheat in a spa?
OHH: Overheat. One sensor has detected 118º. Spa has shut down. OHS: Overheat.. One sensor has detected 110º. Spa has shut down. SnS: Sensors out of balance. If alternating with temp, may be temporary condition.
Why is my Sundance Hot Tub not working?
Pressure switch open – lack of pressure OR for Sundance/Spa Builders/Balboa, pressure switch closed Substantial difference between temperature sensors detected. Could indicate a flow problem Temp above 118 degrees. High limit switch tripped Hi Limit Over Heat. Hi limit sensor is disconnected, shorted, or spa temp is above 112° F
What does dr, dr, dy mean in hot tub?
DR, dr, dy? Inadequate water detected in heater. Inadequate flow in heater. Inadequate flow in heater. (Displays on third occurrence of “dr” message) Flow problem/pressure switch malfunction. Check for low water or clogged filter. Ensure pump is primed.
What are the error codes for a hot tub?
1) Hot Tub Error Codes (Alphabetical) * * * (3 flashing dots under temp displa Flow/Pressure switch either Open or Clos * * * (as above, & red LED lit up on boa High Limit Fault – – – , – – – ‘Watchdog’ – 48C reached, electronic fau – 01 Hi-Limit fault – 02 Temp sensor fault
What to do if your Master Spa has an error code?
Unplug sensor and switch sensors around. If the problem switches to SnB, then you have a bad sensor. If the problem stays SnA, then you have a bad PC board. Same with the error SnB. Find replacement PC board. Sensors are out of balance. If this alternating with the temp, it may just be a temporary condition.
Pressure switch open – lack of pressure OR for Sundance/Spa Builders/Balboa, pressure switch closed Substantial difference between temperature sensors detected. Could indicate a flow problem Temp above 118 degrees. High limit switch tripped Hi Limit Over Heat. Hi limit sensor is disconnected, shorted, or spa temp is above 112° F
Is there an error code for Leslie’s pool?
Leslie’s is proud to partner with Hot Tub Works to bring you this helpful content on lesliespool.com. The best thing about digital spas and hot tubs – those with a spa side control panel – is that you are given error codes for most equipment problems.
