How many valve actuators can an aqua logic Aql-P-4 control?

The AQL-P-4 can control up to 4 high voltage (120/240V) pieces of equipment, up to 3 automatic valve actuators, and a conventional and solar heater. Both manual and automatic (programmed) operation are available.

What is the default display on Aqua logic?

Turn power on at the main panel and turn the Aqua Logic control power circuit breaker on. The keypad will show the default display. The default display alternates between the day/time, air and pool (or spa) temperature, pool/spa sanitizer setting, and salt level.

What can Aqua logic be used to control?

The Aqua Logic can control pumps, valves, lighting, heaters, and chlorination. Although the Aqua Logic is easy to use, it is important to completely read through this operating manual before attempting to operate the control. NOTE: This manual assumes that the Aqua Logic has been wired and configured according to the Instal- lation Manual.

When does Aqua logic P4 show low salt?

My experience, 10 years with an Aqua Logic P4, and currently on my 3rd cell, is that I get low salt when the salt is not low for some time before the cell completely dies. So, yeah, probably new cell time for you. You must log in or register to reply here.

How big of a pool does Aqua logic need?

The Aqua Logic is designed to handle the purification needs of most residential swimming pools up to 40,000 gallons (150,000 liters), or the needs of most commercial pools up to 25,000 gallons (95,000 liters). Check local codes for other restrictions.

What do you need to know about the Aqua logic?

The Aqua Logic is a multifunction pool controller used to fully manage your pool/spa system. The Aqua Logic can control pumps, valves, lighting, heaters, and chlorination. Although the Aqua Logic is easy to use, it is important to completely read through this operating manual before attempting to operate the control.

Where is the keypad on an aqua logic pool?

Every Aqua Logic system includes a main control unit with a 100 amps subpanel and built-in display/keypad for programming directly from the equipment pad. Pool service personnel do not need access to the keypad located inside the house.