How long to run jet pump on low speed?
Then select the “Temp Up” or “Temp Down” arrows to choose the length of the filter time preferred. The timer will run the jet pump on low speed for the 60 minutes during the filter cycle, and 12 hours after that for 30 minutes.
How do I change the filtration cycle on my pump?
To change the filtration cycle: 1. Press the Tempbutton then the Jetsbutton. 2. Press Tempbutton again to change the filtering cycle duration. See the table at right for filtration settings and duration. 3. When desired duration is selected press the Jetsbutton to exit.
How do you set timer on caldera spa jet pump?
Press “Light” to select between Filter Cycle 1 or 2. Then select the “Temp Up” or “Temp Down” arrows to choose the length of the filter time preferred. The timer will run the jet pump on low speed for the 60 minutes during the filter cycle, and 12 hours after that for 30 minutes.
When does the circulation pump start and end?
The circulation pump operates during filtration cycles and during heat demand. It is capable of running continuously if the filtration cycle is programmed accordingly. Spas are programmed to filter twice a day. The first cycle will begin 6 minutes after the spa is turned on and the second cycle 12 hours later.
Then select the “Temp Up” or “Temp Down” arrows to choose the length of the filter time preferred. The timer will run the jet pump on low speed for the 60 minutes during the filter cycle, and 12 hours after that for 30 minutes.
How to know if a jet pump is out of adjustment?
1 The voltage is too low. 2 The circuit breaker has tripped or a fuse has blown. 3 The pressure switch is out of adjustment.
What happens if my pool pump cannot run at high speed?
If you cannot operate your pump at high speed, you may lose the ability to control your waterfalls, pop-up heads, spillovers, jets, and bubblers. Water features typically require more gallons per minute (GPM) than what the low speed on pumps produce.
How does a pump with speed control operate?
During the speed reduction of a pump, duty points of a pumping system with a mainly static head move to the left further from BEP toward the lower efficiency. How does pump with speed control operate in a pumping system without static head and only friction losses?
Why is the motor on my jet pump not working?
The pump’s motor is set to incorrect voltage, or, voltage being fed to motor does not match the motor’s rated voltage. The hose from the pump body to the pressure switch is blocked, clogged, or frozen or has come off one end. The pressure switch contacts are dirty or burned. The power wires are loose or disconnected.
What to do if your jet pump is too high?
Clean parts if required. Impeller worn or plugged, no jet assembly installed, or jet plugged: Install jet assembly or unclog as required. System head too high: If head cannot be changed, replace pump with suitable unit. Suction lift or suction losses excessive: Lower pump and or replace excessive amount of fittings in the line.
If you cannot operate your pump at high speed, you may lose the ability to control your waterfalls, pop-up heads, spillovers, jets, and bubblers. Water features typically require more gallons per minute (GPM) than what the low speed on pumps produce.
