How long should it take a spa to heat up?
If your hot tub is located inside, and the air temp is around 76 degrees, it will take about 4 hours to heat up your spa to 100 degrees. The lower the outside temps the longer you will have to wait before your spa is ready. Therefore, by leaving the cover on while it’s heating up you can help it warm up faster.
Are there Blue Ridge Gatsby spas replacement parts?
Blue Ridge – Gatsby Spas Parts listed are NON- BRANDED replacement parts ( Generic replacement parts ) from the same part manufactures. Others are Replacements that will work as well or better. The listing is meant as a aid in finding your replacement parts faster.
What to do if your spa heater does not heat?
Once they are removed, tape them together; turn the thermostat dial down to the off position, and turn the power back on. Make sure the spa is on the heater/filter cycle and water is flowing from the jets, turn the thermostat dial up while watching the contactor, if it closes when doing this, then re-test the heater using the amp-meter.
Is the heat indicator light on on my hot tub?
No, It Is Not: If you are not getting any error messages in the display screen (blinking dots is an error message) then please proceed, otherwise find the steps below to troubleshoot error messages. In order for the spa to heat, the heat indicator light needs to be on on the topside control.
What are the different error codes for hot tubs?
There are several different error codes that are used by many different manufacturers. The predominant manufacturers are Balboa, Gecko and Hydro Quip. The error code that we are going to look at here is “FLO” or 3 blinking dots. Both mean the same thing and will be troubleshot the same.
Blue Ridge – Gatsby Spas Parts listed are NON- BRANDED replacement parts ( Generic replacement parts ) from the same part manufactures. Others are Replacements that will work as well or better. The listing is meant as a aid in finding your replacement parts faster.
What should I do if my hot tub heater is not working?
Before proceeding make absolutely sure that the pump which circulates water through the heater is passing water through the heater and also make sure you see water movement in the spa! If you don’t confirm water is moving in the hot tub and through the heater do not proceed with the next step as in doing so may burn out the heating element.
No, It Is Not: If you are not getting any error messages in the display screen (blinking dots is an error message) then please proceed, otherwise find the steps below to troubleshoot error messages. In order for the spa to heat, the heat indicator light needs to be on on the topside control.
There are several different error codes that are used by many different manufacturers. The predominant manufacturers are Balboa, Gecko and Hydro Quip. The error code that we are going to look at here is “FLO” or 3 blinking dots. Both mean the same thing and will be troubleshot the same.
