How long does it take to prime a hot tub pump?
There are two methods of priming the pump. Turn the spa on and wait for PR (Priming Mode) to appear on the topside display. Press the JETS button to turn on the pump and let it run for 10 seconds. The pump should be running in low speed. Press the JETS buttons again and let the pump run in high speed for 10 seconds.
When do I need to replace my hot tub pump?
A common problem with older spas is pump failure. We will guide you through spa pump replacement, restoring your hot tub for many years of enjoyment. If your system is more than 2-3 years old, replace the entire pump, not just the motor or wet end. You’ll have fewer headaches in the long run.
How do you hook up a pressure switch to a hot tub?
Unplug the pressure switch cable from the circuit board, thus revealing two pins. Power up the system. As soon as the low/filter pump turns on, jump the two pressure switch pins on the board with alligator clips. Don’t worry, you will not get shocked as the pins are low voltage.
What to do if your hot tub pressure switch is defective?
To check to see if the pressure switch is defective or miscalibrated, please do the following: Power down the circuit board. Unplug the pressure switch cable from the circuit board, thus revealing two pins. Power up the system. As soon as the low/filter pump turns on, jump the two pressure switch pins on the board with alligator clips.
Why does my hot tub keep Tripping the circuit board?
If the GFCI holds, then you have found the cause of the GFCI tripping. It will need to be replaced. If you have everything unplugged (including the main pump) and it still trips, then there may be an issue with the transformer that is soldered or plugged into the circuit board. If the transformer plugs into the board it can be easily replaced.
Unplug the pressure switch cable from the circuit board, thus revealing two pins. Power up the system. As soon as the low/filter pump turns on, jump the two pressure switch pins on the board with alligator clips. Don’t worry, you will not get shocked as the pins are low voltage.
What to do if your hot tub circulation pump is not working?
Disconnect the plumbing and turn it on very briefly to see if any funny noises are made. Depending on the location of the problem, a replacement of the bearings, motor, entire circulation pump will be required. Pro-Tip: Your spa circulation pump should run with as little noise as possible.
To check to see if the pressure switch is defective or miscalibrated, please do the following: Power down the circuit board. Unplug the pressure switch cable from the circuit board, thus revealing two pins. Power up the system. As soon as the low/filter pump turns on, jump the two pressure switch pins on the board with alligator clips.
How long does it take for a hot tub pump to come on?
Make sure that a rodent has not chewed through the cable. NOTE: When you unplug the topside control from the circuit board, the low speed/filter speed should come on in approximately one minute. If it does not, then either the pump or the circuit board is faulty.
