How long does a hot tub heater element last?
The number one cause of heater failure is poor water chemistry. Will good water balance and monthly testing with your professional hot tub dealer, Hot tub heaters can last a long time. The average life of a hot tub heater is about 5 years.
How to tell if your hot tub heater element is bad?
240V Spas With the spa on, test both of the leads on the element at the same time. If the meter is reading 240v, the element is the problem. If the meter is reading zero, the problem is with the circuit board. 120V Spas With the spa on, test both of the leads on the element at the same time. If the meter is reading 120v, the element is the problem.
How to troubleshoot hot tub and spa equipment pack?
Using volt meter on a minimum 240 volt scale (120 on a 120 pack) check to see whether the power coming in is enough to power the pack: 210-240 on 240v, 110-120 on 120v. If not, have an electrician look into it. On 240v observe contactor or heater relay.
What happens when the spa heater is in standard mode?
If the set temperature is higher than the displayed current water temperature, and the spa is in standard mode, then the control system will call for heat and the heater should start up with the pump on low speed (or the circ pump operating).
Why does my M7 spa heater keep overheating?
Press any button to reset (there is no auto-reset). The spa water overheat error message is OHS and it means one of the sensors has detected 110F degrees incoming water. This can happen if the filter cycle settings are improperly setup so the spa is constantly cycling (did you mix up AM and PM?). Otherwise maybe it is really hot outside?
240V Spas With the spa on, test both of the leads on the element at the same time. If the meter is reading 240v, the element is the problem. If the meter is reading zero, the problem is with the circuit board. 120V Spas With the spa on, test both of the leads on the element at the same time. If the meter is reading 120v, the element is the problem.
Do you need to replace the spa pack?
The spa pack is essentially the brain of your spa. If you find you need to replace the circuit board, it is very important to make sure you replace it with the correct board. Many boards look identical; however their software may be different.
What do I need to replace my gecko hot tub board?
Each one of their boards has a part number on a large white label placed directly onto the circuit board. To properly identify the correct HydroQuip board, simply match the part number on the label. To properly identify the correct replacement for a Gecko circuit board, you will need the “Model” and “Options” numbers.
What to do when you need to replace a hot tub circuit board?
Make sure that when you’re replacing a circuit board (or any other electrical component) that the power is completely disconnected. If you do not feel confident replacing the circuit board yourself, seek the help of a hot tub technician or licensed electrician.
