How long do vinyl above ground pools last?
Above ground pool liners will last 6–10 years in most cases. The factors that dictate their longevity are essentially the same as those of an inground liner. Don’t hesitate to add comments or questions below.
How much does it cost to replace an inground pool with vinyl?
Homeowners with pools can generally expect to spend between $1,000 and $3,400, or on average about $2,200, to repair or replace an inground or above-ground vinyl swimming pool liner. If you’re looking to just patch a small hole, that should only set you back around $350.
How long do Vinyl Pools last?
between 10 and 15 years
A typical vinyl liner lasts between 10 and 15 years, though there are many factors that can affect its lifespan. Living in an area susceptible to ground water problems can reduce your liner’s life, as can not keeping the water in your pool balanced.
Can a vinyl pool liner be lifted off the ground?
This is commonly called a “floating” liner. Issues with ground water are not unique to vinyl liners – ground water has been known to lift whole pools out of the ground if the surrounding drainage is not sufficient. Fibreglass style pools and even concrete pool shells have been known to “pop up” or move in severe ground water situations.
What causes a vinyl pool liner to tear?
Types of Vinyl Pool Liner Damage: Liner bead pops out or “jumps the track”. Liner rips or tears due to sharp foreign object. Liner ages and fails above the water line.
Is it possible to repair an inground pool liner?
Pool liner problems can often be repaired if the liner is not too old. Inground liner repair is cheaper and easier than replacing the entire liner. Our pool liner repair section addresses bead issues, cuts, tears, rips, and liner failure above the water line.
Why does the vinyl on my Pool Deck pop out?
Constant fluctuations in temperature over the winter can cause the vinyl to stretch and pop out at certain spots—most often at corners or where there is plastic trim in a concrete deck that meets with the pool coping. In many cases, the vinyl can be pulled up and snapped back into place in just a few minutes.
This is commonly called a “floating” liner. Issues with ground water are not unique to vinyl liners – ground water has been known to lift whole pools out of the ground if the surrounding drainage is not sufficient. Fibreglass style pools and even concrete pool shells have been known to “pop up” or move in severe ground water situations.
Types of Vinyl Pool Liner Damage: Liner bead pops out or “jumps the track”. Liner rips or tears due to sharp foreign object. Liner ages and fails above the water line.
Constant fluctuations in temperature over the winter can cause the vinyl to stretch and pop out at certain spots—most often at corners or where there is plastic trim in a concrete deck that meets with the pool coping. In many cases, the vinyl can be pulled up and snapped back into place in just a few minutes.
Why is the pool liner pulling away from the wall?
The liner is about a half inch away from the wall – only at the top corners. I don’t think it’s an air pocket – yes there is air but only because the liner is tight. If the liner were to stretch and reach the wall the air would be gone.
