How is the zone valve on a hot water heater controlled?
Each zone valve is controlled by its own zone thermostat. End switches in each zone valve control the central circulator and the burner. On a call for heat, the valve is opened.
What should I do if my hot water zone is not working?
Observe the control devices; the valve should close. The auxiliary equipment should stop unless the end switches are wired in parallel and another zone is calling for heat. If the auxiliary equipment continues to run when the zone valve satisfies, lower the setpoints below room temperature on all the zones and repeat the procedure.
What causes hot water to run through the heating zone?
This motor can sometimes break or wear down, and the valve will stay closed or open. An open valve will cause hot water to run through the heating zone whenever the furnace turns on.
How to troubleshoot a malfunctioning heating zone?
Locate the thermostat that controls the heat in the zone that is cold. Pull the thermostat off the wall and look to see where the wires lead. For example, the wires may lead straight down into the basement. Go into your basement, locate the wall were the wires led downward, find the thermostat wires, and follow them to the zone valve.
Why is my heating zone not working properly?
This issue can typically be fixed with a few easy troubleshooting tasks. Sometimes, a heating zone will not work properly because water cannot move through the baseboard radiators. This happens when an air bubble blocks the pipes.
How to create zones in a hot water heating system?
6 Solder together new zone valve assemblies and attach to boiler with solder-less fittings. 7 Install wireless thermostat in room of new zone; locate thermostat away from direct sunlight or cold drafts, and about 60 inches above the floor.
What is the zone valve on a radiator?
To keep hot water from constantly moving through the radiators, valves close off the water pipes when the area is warm enough. The valves are called zone valves and they are wired directly to your thermostats.
What does it mean when a zone valve breaks?
The valves are called zone valves and they are wired directly to your thermostats. When the zone valve gets the message that the heating zone needs heats, a small motor will open up the valve and hot water will pass through. This motor can sometimes break or wear down, and the valve will stay closed or open.
