How high should toilet drain be from floor?
With the toilet removed, you can see the toilet flange and measure its height above the floor. Optimum flange height to aim for is 1/4 inch above the finished floor. This typically allows for almost any type of wax ring to be used and still ensure a good seal.
What is toilet rough-in distance?
Toilet Rough-In Measurements and Standards Start by measuring the rough-in size. This is the distance between the wall behind the toilet and the center of the drainpipe or the bolts that hold the toilet to the floor. It’s best to perform this measurement before you remove the old toilet.
Where do you place a toilet drain in a bathroom?
The standard placement for a toilet drain in the bathroom is 12 inches from the wall behind the toilet. The 12-inch measurement runs from the wall itself to the dead center of the drain.
How big of a space do you need for a toilet drain?
Most toilets are only about 1 foot wide, but you will need 15 inches of space on either side to properly access the toilet. Therefore, the proper distance for a drain from a side wall is at least 15 inches. This also applies to the distance from cabinets or tubs nest to the toilet.
What’s the proper distance to drain from a side wall?
Therefore, the proper distance for a drain from a side wall is at least 15 inches. This also applies to the distance from cabinets or tubs nest to the toilet.
How big is the hole in the floor for a toilet?
Floor Hole Size. The standard size for the hole over which the toilet flange will be installed is approximately 4 1/2 inches in diameter. This hole is centered, for most toilets, 12 inches from the rear wall behind where the toilet will sit.
How far from the wall should I install a toilet?
Toilets should be around 12 inches away from the wall. When designing or renovating a bathroom, you’ll need to know the toilet rough-in placement and measurement. This is how far the floor trap or toilet flange is required to be from the wall.
What is the distance from a toilet flange to the wall?
Standard drywall is 1/2 inch thick, so the plumber should set the toilet flange at least 15-1/2 inches from the center of the flange to the wall framing. The standard distance from the back wall is 12 inches, or 12-1/2 inches from the center of the flange to the wall framing.
What is the distance from toilet to wall?
The minimum distance between the toilet and a finished wall on either side is 15 inches. This is measured from the toilet’s centerline, not from the outside edge. The plumber determines the actual distance when he sets the toilet flange in the floor.
