How far should the center of the toilet be from the wall?
15 inches
Most codes require at least 15 inches (measured from the center of the toilet) from any side wall or obstruction and not closer than 30 inches center to center to any other sanitary fixture. (The NKBA actually recommends 32 inches.) There should be at least 24 inches of clear space in front of a toilet or bidet.
How do you measure rough in for a new toilet?
The rough-in measurement of a toilet refers to the span between the wall behind the toilet and the center of the waste pipe. To measure the rough-in for your toilet, measure from the wall behind the toilet to the middle of the bolt caps (the caps holding your toilet to the floor).
How to measure the rough in distance of a toilet?
How to Take a Toilet Rough-In Measurement You want to measure the distance from the wall to the bolt caps at the center of the discharge. The general rule of thumb for clearance from the wall that faces the bowl is 24″ and just about 15″ on each side.
What does rough in mean for a toilet?
A rough in is a term used to describe the measurements and plumbing required for a proper installation of a toilet. The basic rough in for a toilet will only cover the distance from the wall to drain flange. However, it is much more than that.
What’s the distance from the wall to the center of the toilet?
In most cases, the distance from the wall to the center of the toilet is usually 12 inches and this is what is referred to as 12 inch rough in for a toilet.
What do you need to know about the dimensions of a toilet?
The next measurement you need to know is: #2: The Clearance From the Center of the Toilet To Any Adjacent Fixture or Sidewall. This measurement is 15 inches. That’s the minimum (you can have more). So looking at the toilet, make sure there are at least 15 inches of clearance from the center of the toilet to any adjacent fixture (or wall).
How to Take a Toilet Rough-In Measurement You want to measure the distance from the wall to the bolt caps at the center of the discharge. The general rule of thumb for clearance from the wall that faces the bowl is 24″ and just about 15″ on each side.
How big is a rough opening for a toilet?
Most rough openings are 12 inches, but can be as little as 10 inches and as much as 14 inches. 1 Place the end of a tape measure against the wall behind the existing toilet, not on the molding at the base of the wall.
What does rough in mean on a toilet?
The rough-in measurement indicates how much clearance you have and will allow you to select a compatible toilet. There are a few common errors when it comes to measuring a toilet rough-in. You will want to be sure to avoid these pitfalls:
What is the distance between the toilet and the wall?
The toilet flange distance from wall (also known as a closet flange) is the pipe fitting which mounts a toilet to the floor, connecting the toilet drain to the drain pipe. The distance of the toilet flange from the back wall depends on whether or not the construction is new or if a finished wall already exists.
