How far should a shower handle turn?
Your goal is to center the shower valve between studs 12 inches apart. The handle sticks out about 3.75 inches+ from the finished wall ( the gap between the handle cover and the wall plate is about 1 1/4 inch.
What height should the shower valve be?
Shower Valve Height A height of 28 inches, or 2 feet 4 inches, is standard for valves in bathtub shower units. For shower stalls, install the valve at the standard height of 48 inches, or 4 feet. Install faucets at the same height as the valve, equidistant from the valve.
Can a 2 or 3 handle shower valve go bad?
In older bathrooms, a 2 or 3 handle Tub, Shower, or Tub and Shower valve can go bad, break or be a brand that uses parts that are no longer available. Some plumbers will tell you a tile repair man will be needed after they replace your valve.
How big of a space do you need for a swinging shower door?
The shower enclosure must permit unobstructed access to a showering person in case of a fall. However, your shower door can open in both directions, outward-opening and inward-swinging. You’ll need about 30″ of clearance space outside your shower to install a swinging shower door.
Where do you replace the handle on a shower knob?
You may need to replace the knob or handle altogether. To replace it, you’ll need to first turn off the shower water shutoff valve — generally located behind the tub or shower access panel. If you can’t shut off the valve, you can turn off the water supply to your house.
What to do if your shower handle is loose?
Once everything is in place, reattach the shower handle — new or old — and turn the water supply back on. A loose shower knob could be due to a worn valve stem, especially if the stem is plastic. In that case, you can use plumber’s tape to fix it.
You may need to replace the knob or handle altogether. To replace it, you’ll need to first turn off the shower water shutoff valve — generally located behind the tub or shower access panel. If you can’t shut off the valve, you can turn off the water supply to your house.
Once everything is in place, reattach the shower handle — new or old — and turn the water supply back on. A loose shower knob could be due to a worn valve stem, especially if the stem is plastic. In that case, you can use plumber’s tape to fix it.
What should the slope of the shower seat be?
Slope of Curb The curb or lip around the bottom of the shower should to be slanted inward at a 5-degree (approx. 3/16″ to 1/4″) “pitch” or slope so water flows in toward the drain. (A level curb would cause the water to stand, while a curb angled away from the drain would cause water to leak onto the bathroom floor.) Slope of Shower Seat
How much space do you need for a two person shower?
You should use at least 3 feet of spacing between shower heads that are on the same wall to give each person room to maneuver freely, but again this is up to personal comfort level of the couple in question.
