How does the water level in a hot tub work?
Water Level and Filter Function. The filter sucks water into the internal plumbing of the hot tub and filters out debris. The water level inside the hot tub must be high enough so that the water flows inside the filter or the pump will not work properly.
What to do if your hot tub flow switch is not working?
While you are checking the valve position, check the valve to make sure there are no obstructions. If anything is stuck in the valve holding it open, the unit will not work properly. Remove the obstruction and try to turn the unit on. Look at the water level in the hot tub. If the water level is lower than the jets, the flow switch will not work.
How can I level my hot tub on pavers?
If your hot tub is already installed on pavers, but you need to level your hot tub, the best thing to do is use shims. As previously stated, refer to your hot tub owners manual. It should detail how to place the shims
Why is my hot tub running without water?
You did not say what spa you have, so it’s hard to tell if any damage was done. Most spas have an over-temperature sensor that turns them off if the heater is on but the circulator pump is not running, but this relies on the spa being filled with water. Basically I think it depends on the heater in your spa.
Water Level and Filter Function. The filter sucks water into the internal plumbing of the hot tub and filters out debris. The water level inside the hot tub must be high enough so that the water flows inside the filter or the pump will not work properly.
If your hot tub is already installed on pavers, but you need to level your hot tub, the best thing to do is use shims. As previously stated, refer to your hot tub owners manual. It should detail how to place the shims
How tall should I Fill my hot tub with water?
Look for the hot tub filter, normally located on the side of the tub. Fill the hot tub with water to about 2 to 3 inches above the top of the filter. Do not fill the hot tub above this level. As the jets are turned on and people get inside the hot tub, the water level will naturally rise.
What should I do if my hot tub is leaking?
To have consistently clean and clear water, follow ThermoSpas’ recommended chemical maintenance schedule: Check for leaks by walking around the spa and looking at the base of the cabinet for signs of water. Be sure the spa cover is in place and tied down to the spa. Remove any foreign objects or debris that may have fallen into the spa
