How does the transfer switch 30-go power work?

1. Introduction The Go Power! Transfer Switch-30 amp (TS-30) provides automatic power switching between two separate 120 volt AC input sources, including power cords, onboard generators, or onboard inverters. The TS-30 will sense the presence of available power supplies and automatically select the proper one.

Where to mount a TS-30 power transfer switch?

If possible, mount the TS-30 near the power cord entry or the location of the generator output. Typical locations include under counter cabinets, below closet compartments, inside the bed pedestal or cabinets, overhead cabinets, under-floor storage compartments accessed from the vehicle exterior, etc.

Where to mount a GPTs 30-go power switch?

The TS-30 mounting location may be on any interior surface where the unit will be out of direct weather. The chosen location must be accessible after installation is complete to facilitate future servicing. If possible, mount the TS-30 near the power cord entry or the location of the generator output.

How to safely install an inverter for AC power?

1 1 – Install a dedicated AC circuit for your power inverter 2 Option #2 – Use a relay to automatically disconnect your battery charger 3 Option #3 (Best) – Wire your battery charger to run only on shore power

What does a Go Power 30 AMP transfer switch do?

An automatic transfer switch is usually installed to allow both your inverter and shore power to alternatively feed the circuits and prevent AC back feed. The Go Power! TS-30 is a 30 amp AC switch that automatically connects shore power (when available) to your breaker panel.