How does an Accu-slide cable slide room work?
Thanks to a simple setup of cable pulleys and chain gears, the room can be pushed out and pulled in in a matter of seconds. And because it gets its juice from the house 12-volt battery, the Accu-Slide doesn’t need any special rig or cumbersome battery mounting.
Why does my Thor not have a full Wall Slide?
With the engine running it gives more power to run the slide in or out. There is a small pressure switch that may need adjusting with a small screwdriver. Normally in your basement below the slide. I had a similar problem with one of the slides on our coach. However, we don’t have a full wall slide.
What to do if your Slide Room is not working?
To provide more specific troubleshooting information on your slideroom issue we need the type of slide and the mechanism. If it’s a hydraulic slide mechanism I would start by checking the hydraulic fluid level. If it is low, the motor will run but will be pushing air and does not have enough pressure to move the room.
How often should you treat a cable slide room?
It’s also a good idea to treat the rubber gaskets once a year with ProtectAll Conditioner to make them soft and visually inspect to make sure the gasket is attached and in good condition. One more tip; make sure the roof is clean of debris such as sticks and acorns before bringing the room in.
Thanks to a simple setup of cable pulleys and chain gears, the room can be pushed out and pulled in in a matter of seconds. And because it gets its juice from the house 12-volt battery, the Accu-Slide doesn’t need any special rig or cumbersome battery mounting.
With the engine running it gives more power to run the slide in or out. There is a small pressure switch that may need adjusting with a small screwdriver. Normally in your basement below the slide. I had a similar problem with one of the slides on our coach. However, we don’t have a full wall slide.
To provide more specific troubleshooting information on your slideroom issue we need the type of slide and the mechanism. If it’s a hydraulic slide mechanism I would start by checking the hydraulic fluid level. If it is low, the motor will run but will be pushing air and does not have enough pressure to move the room.
It’s also a good idea to treat the rubber gaskets once a year with ProtectAll Conditioner to make them soft and visually inspect to make sure the gasket is attached and in good condition. One more tip; make sure the roof is clean of debris such as sticks and acorns before bringing the room in.
