How do you use Atwood level legs?

How do you use Atwood level legs?

To manually level, I start by pressing the AUTO button until the jacks just touch, then press the AUTO to stop the process. Then pressing the EXT button, press the FRONT, REAR, DRIVER, PASS (depending on which side you need leveled) until you reach your goal.

How to retract jacks on Atwood levelegs system?

Reconnect jack to power. Manually extend individual jacks for 10 seconds by holding down the EXT key and the two jack keys that make up the camper corner of that jack. Listen to insure all jacks move when manually activated. Press RET and ALL to retract all jacks. 2 RED AND GREEN LIGHTS COME ON FOR A SPECIFIC JACK LOCATION Cause:

Is the Atwood leveling system electric or gas?

The Atwood system is electric. The face of the system states, “Atwood P/N 66273”. Opps typo, my coach is 2005. Location:Where ever the wheels stop ?

Where can I buy an Atwood Jack controller?

CRC is sold at many auto supply stores or in some electronic supply outlets. I am using my 4th or 5th Atwood jack controller on my 2006 Fleetwood Expedition at $525 each. The controller is no longer available.

What causes short Jack extension on Atwood camper?

Cause: Short jack extension followed by jack retraction. Solution: Put system in error mode by disconnecting one jack from power and pressing RET and ALL. Reconnect jack to power. Manually extend individual jacks for 10 seconds by holding down the EXT key and the two jack keys that make up the camper corner of that jack.

Why is my Atwood levelegs not turning off?

JACK CONTINUES TO CLUTCH AND WILL NOT TURN OFF Cause: Short jack extension followed by jack retraction. Solution: Put system in error mode by disconnecting one jack from power and pressing RET and ALL. Reconnect jack to power.

How big are the power jacks on Atwood levelegs?

The size is about #22 gauge. These are signal wires only with mini Walden-Molex connectors. The power wires are not a problem. They are about #8 gauge. The connectors to that feed the individual jacks have # 10 or #12 wire and have never been a problem.

CRC is sold at many auto supply stores or in some electronic supply outlets. I am using my 4th or 5th Atwood jack controller on my 2006 Fleetwood Expedition at $525 each. The controller is no longer available.

Is the Atwood levelegs grounded on the same bus?

It could be a poor ground, but according to the diagram, all four motors are grounded on the same buss. Check voltage with a digital voltmeter at the control panel while deploying the jacks. If 12+VDC, I would suggest giving Atwood a call at 800-546-8759.

You Might Also Like