How do you unlock the configuration Menu in Aqua Logic?
Press the ‘Menu’ until, ‘Configuration Menu-Locked’ appears. To unlock, press and hold the (<) & (>) until the text, on the display, changes from ‘Locked’ to ‘Unlocked’ (unit will beep).
What can Aqua logic be used to control?
The Aqua Logic can control pumps, valves, lighting, heaters, and chlorination. Although the Aqua Logic is easy to use, it is important to completely read through this operating manual before attempting to operate the control. NOTE: This manual assumes that the Aqua Logic has been wired and configured according to the Instal- lation Manual.
How to turn off flow control on ProLogic?
Press the Menu button repeatedly, until the Diagnostic Menu appears. Then press (>) one time. If all zeros or if Chlorinator Off Percentage Met, press ~+ key. IF, after a short countdown delay, the display does not revert to zeros, refer to step 3.
When to use Hayward diagnosti chlorinat AUT no flow LED flashing?
O HAYWARD Diagnosti Chlorinat Aut No Flow LED flashing or ON No Flow LED will flash for up to 60 seconds on start-up. No Flow LED will be ON when there is a flow switch problem. Power Generating Super Chlorinate Remotely Controlled -r No Flow Cheek Salt High Salt nSpect Cell If LED is ON, check for flow switch installed backward.
How to restore AquaLogic pool to factory default?
Follow these steps ONLY if you wish to restore the system to factory default. WARNING: Resetting the system to factory default will wipe out all configuration changes, schedules, and settings preferences. Once the reset has been completed, the display will report ZConfig. Reset Confirmed. To exit Config., press the Menu
The Aqua Logic can control pumps, valves, lighting, heaters, and chlorination. Although the Aqua Logic is easy to use, it is important to completely read through this operating manual before attempting to operate the control. NOTE: This manual assumes that the Aqua Logic has been wired and configured according to the Instal- lation Manual.
What are the different error codes for Hayward Aqua rite?
If you take a look at the picture on the left, there are only 4 different error functions: No Flow, Check Salt, High Salt, and Inspect Cell. Although there may be several reasons for the error code to appear, having only 4 possibilities is great odds for a pool owner.
O HAYWARD Diagnosti Chlorinat Aut No Flow LED flashing or ON No Flow LED will flash for up to 60 seconds on start-up. No Flow LED will be ON when there is a flow switch problem. Power Generating Super Chlorinate Remotely Controlled -r No Flow Cheek Salt High Salt nSpect Cell If LED is ON, check for flow switch installed backward.
Press the Menu button repeatedly, until the Diagnostic Menu appears. Then press (>) one time. If all zeros or if Chlorinator Off Percentage Met, press \~+ key. IF, after a short countdown delay, the display does not revert to zeros, refer to step 3.
