How do you turn the temperature up on a Balboa hot tub?
To change the set temperature, press a temperature button again before the display stops flashing. Each press of “Warm” or “Cool” will adjust the set temperature. After three seconds, the display will stop flashing and begin to display the current spa temperature.
How to change the temp on the Balboa?
High Range can be set between 26.5°C to 40°C. Low Range can be set between 10°C to 36°C. To change the range press the temp/warm button followed by the light button, then press temp/warm button again. To exit, press the light button or wait for 10 seconds to go back to the Main Screen.
What are the temperature buttons on a control panel?
Some panels have separate WARM(Up) and COOL(Down) buttons, while others have a single Temperaturebutton. In the navigation diagrams Temperature buttons are indicated by a single button icon. Panels that have two Temperature buttons (Warm and Cool) can use both of them to simplify navigation and programming where a single Temperature icon is shown.
Where is the control box on a Balboa spa?
1. Remove the screws and cabinet panel on the side of the spa under the topside control panel, and then set the cabinet panel aside. 2. After removing the cabinet panel, locate the electrical control box. Loosen the screws on the front of the control box. Remove the screws and the control box cover.
What does the lightbutton do on the Balboa water control panel?
The LIGHTButton is also used to choose the various menus and navigate each section. Typical use of the Temperature button(s) allows changing the Set Temperature while the numbers are flashing in the LCD. Pressing the LIGHTbutton while the numbers are flashing will enter the menus.
Where are the sensors on a Balboa hot tub?
Note: The below images refer to a Toronto Spa for the location of the control system. Placement varies from spa to spa, but in any case it will be located along the same side of the hot tub as the main control panel. Step 3: Locate the heater’s sensor wires and trace them to where they plug into the circuit board (pictures below).
How do you change the temp on a Balboa?
High Range can be set between 26.5°C to 40°C. Low Range can be set between 10°C to 36°C. To change the range press the temp/warm button followed by the light button, then press temp/warm button again.
What is the installation manual for a Balboa spa?
End User Warning This Installation Manual is provided solely to aid qualified spa service technicians in installing spas with control systems manufactured by Balboa Water Group. Balboa controls have absolutely no end user serviceable parts.
How do I change the temperature on my spa?
Press the “Cool” or “Warm” button once to display the set temperature. Each time either button is pressed again, the set temperature will increase or decrease depending on which button is pressed. After three seconds, the LCD will automatically display the last measured spa temperature. Mode ML500, 551, 554
