How do you troubleshoot an Intex saltwater system?

How do you troubleshoot an Intex saltwater system?

Possible problems include:

1. Dirt or scale has built up on the titanium plates: Remove the electrolytic cell and inspect it; clean it if necessary.
2. Low salt level, or no salt: Add salt to the system.
3. Electrolytic cord is loose: Make sure the plug is securely inserted.

Why is my Intex salt water system giving error code 90?

We turned off both systems, and purged the air from the lines on our Krystal Clear 637R pump. That did it. We turned everything back on, and it didn’t give the error code. Somewhere between hour 2-3, it gave the error code again. Purged the lines again, turned it back on, and fine.

When do you need help with an Intex saltwater system?

Need help with Intex saltwater system! if the system is saying low flow,the pump isn’t pushing the water hard enough through the salt system.Make sure you keep the filter clean.If this doesn’t correct the problem you’ll need a larger pump!

Is there a FP code on my Intex cs8110?

That’s very strange that you have a “FP” code on that system, it sounds like Intex is using the same exact board to operate both models! In any case, the only way to get that code to go away on Intex systems is by holding those two arrow buttons I mentioned above at the same time, if that doesn’t work then you have me beat.

How to get code FP to go away on Intex?

In any case, the only way to get that code to go away on Intex systems is by holding those two arrow buttons I mentioned above at the same time, if that doesn’t work then you have me beat. I have to say I laughed when I read this one!

We turned off both systems, and purged the air from the lines on our Krystal Clear 637R pump. That did it. We turned everything back on, and it didn’t give the error code. Somewhere between hour 2-3, it gave the error code again. Purged the lines again, turned it back on, and fine.

Need help with Intex saltwater system! if the system is saying low flow,the pump isn’t pushing the water hard enough through the salt system.Make sure you keep the filter clean.If this doesn’t correct the problem you’ll need a larger pump!

That’s very strange that you have a “FP” code on that system, it sounds like Intex is using the same exact board to operate both models! In any case, the only way to get that code to go away on Intex systems is by holding those two arrow buttons I mentioned above at the same time, if that doesn’t work then you have me beat.

In any case, the only way to get that code to go away on Intex systems is by holding those two arrow buttons I mentioned above at the same time, if that doesn’t work then you have me beat. I have to say I laughed when I read this one!