How do you reset the salt level on Aqua Rite?
To reset, move the switch to ‘Off’ and then back to ‘Auto’. Wait for the relay to click (5 to 10 seconds). When the instant salt level is stable (and the negative sign still present), slide switch to ‘Super Chlorinate’ and back to ‘Auto’. It takes about 30 seconds for the unit to settle back on the default reading.
Why is the salt level on my Hayward Aqua rite not right?
Occasionally the salt level on the Hayward Aqua Rite may not match the actual salt level of the pool. If the salt cell is clean but the salt reading is off, the Aqua Rite will need to be re-calibrated. The following video will provide a guide on how to recalibrate a Hayward Aqua Rite.
How do I change the salt reading on my aquarite?
To change the default reading back to the average salt, start by pressing the Diagnostics button two times. Continue moving the switch up to Super Chlorinate and back to Auto until the display reads AL-0. It takes about 30 seconds for the unit to settle back on the default reading.
How to check the flow of an aquarite?
1. Check Salt & Inspect Cell: flashing or ON 16-18 2. High Salt: LED ON 19-22 3. No Flow: LED flashing or ON 23-26 4. Display ONLY, Lights ONLY, or Neither 27 5. LCD: Displaying HOT or COLD 28 Additional Information: Pg. 29-32 Salt Addition Table 30 Chlorine Output & Salt Levels 31-32 3 AquaRite: How It Works
Why is my Hayward Aqua rite Turbo cell not working?
This will lock that number in as the new average salt reading. If the salt system settles on a number that is unrealistic, there may be something wrong with your system or salt cell. The most likely issue is that your salt cell needs to be replaced. It could also be that the board in your power center needs to be replaced.
Why is the high salt light on on my Aqua rite?
High Salt LED is also on if the control is set for the wrong Turbo Cell type. The LCD screen will read “HI”. Verify that the salt level is 2700 – 3400 ppm. We recommend that you check the salt level with a water test kit to ensure accuracy.
What should salt level be on Hayward Aqua rite?
Press and hold the diagnostic button for 3 to 5 seconds. The LED light should go out. Your salt level is between 2500-2600 parts per million (ppm). Your chlorine generator is still producing chlorine at the moment, which is a good thing.
Do you have to test salt before adding to aquarite?
It does some mathematical calculations and comes up with a salinity level of your pool. As a rule with any Goldline/Hayward salt generator you should only use the salinity display as a suggestion of the salinity level. Always have the salt tested independently of the unit to confirm the salt level before adding salt.
Why does my aquarite read too much salt?
Always have the salt tested independently of the unit to confirm the salt level before adding salt. Your over salting of the pool is not unusual because many people take the reading on their display as the actual salt level in the pool, when in fact it is and average salt level and it may be skewed by a failing cell.
