How do you reset the check salt?
To reset, move the switch to ‘Off’ and then back to ‘Auto’. Wait for the relay to click (5 to 10 seconds). stabilize.
How can I check the salt level in my Pool?
Check Cell Light blinks as well as the Low Salt light. The check cell light can be shut off by holding the diagnostic button for 3-sec (comes back on next time pump/system is started). The display reads a salt level of 2600 but it is actually 3200 verified twice by pool store.
What should the check cell salt level be?
If it’s over 2600-2700 the check salt level may be related to the check cell light. It could mean your cell is failing but surely not if it’s only four months old. I hope your solution is this simple. I was told the salt level should be between 2800-3200. The salt level is currently 3200 and all other levels are within range.
How to reset check salt and check cell lights?
I went to my Aqua Rite box and looked to see what it was reading. When the system came and flow was established, the “check salt” and the “check cell” lights both flashed continuosly. I reset the check cell light by holding down diagnostic button. The check salt never stopped flashing. The salt readout on the digital display was 2300.
When does the check salt and inspect cell flash?
The ‘Check Salt’ & ‘Inspect Cell’ LEDs will flash when the cell reports the salt level is between 2400 – 2700ppm. In this condition chlorine is still being produced. The ‘Check Salt’ & ‘Inspect Cell’ LEDs will be ON when the cell reports the salt level is 2300ppm or less.
The ‘Check Salt’ & ‘Inspect Cell’ LEDs will flash when the cell reports the salt level is between 2400 – 2700ppm. In this condition chlorine is still being produced. The ‘Check Salt’ & ‘Inspect Cell’ LEDs will be ON when the cell reports the salt level is 2300ppm or less.
Why do I get a low salt error code?
This is due to the chlorinator cell building up scale on the electrical plates. When you purchase a unit new, it should last several months without this problem coming up. However, you will eventually begin to get the scale and “Low Salt” error codes every 6-8 weeks after that. Fortunately, this problem is fairly simple to fix.
How can you tell when a salt cell is bad?
If this light comes on or you think your cell is not producing chlorine, remove the cell and inspect it. If your Cell is transparent, you will be able to see a white metallic buildup on the plates of a corroded Cell. If you see signs of corrosion, remove and clean the plates of the Cell.
How can I tell if my salt level is too high?
But if it goes down as you would expect, then the salt level probably really is too high. Check under the diagnostics menu for the correct cell size. If you select the cell size to t-3, t-5 or t-9 instead of the correct t-15 then the salt readout from the controller will be high salt. Hello!
