How do you reset error on LCI electronic leveling?
We have heard of this issue before on the Lippert Ground Control systems # LC358590. Here is the recommended procedure for clearing the error code: Extend all jacks at least 6 inches. Then press and hold the RETRACT button until the jacks begin retracting. All of the jacks should fully retract and clear the error.
How do you reset a Lippert leveler?
Resetting Lippert Ground Control Leveling System After Dead…
- In manual mode, run the jacks to level the trailer.
- Once the trailer is level, turn off the touch pad.
- With the touch pad off, press and release the “FRONT” button five (5) times and then press and release the “REAR” button five (5) times.
How do you calibrate a Lippert 3.0 leveling system?
How to Reset Zero Point Calibration on Lippert Ground Control 3.0
- In manual mode, run the jacks to level the trailer.
- Once the trailer is level, turn off the touch pad.
- With the touch pad off, press and release the “FRONT” button five (5) times and then press and release the “REAR” button five (5) times.
How to troubleshoot auto leveling system on Thor Ace?
Once reconnected to power if you still have error codes, such as “Out-of-Stroke”, to clear this code you can extend all of the jacks in the system at least 6 inches. Then press and hold the retract button until the jacks start to retract. All of the jacks should fully retract and the error should be cleared.
How long does it take to retract jacks on Thor Ace?
Usually about 15-minutes without power does it. Once reconnected to power if you still have error codes, such as “Out-of-Stroke”, to clear this code you can extend all of the jacks in the system at least 6 inches. Then press and hold the retract button until the jacks start to retract.
What should I do if my leveling jacks are not working?
Silicones and cleaning agents such as Dawn dish soap can worsen the corrosion and render your system irreparable. So what you should do is spray the system well with WD-40 and then wipe clean.
Are there hydraulic leveling jacks on my 2006 Seabreeze?
On our last trip, Dec 2018 with my 2006 National SeaBreeze LX 32′, the hydraulic leveling jacks deployed correctly, but upon leaving they retracted normally, but slow, and then the control panel displayed at least one of them was still down and would sound an alarm when I removed the parking brake.
Once reconnected to power if you still have error codes, such as “Out-of-Stroke”, to clear this code you can extend all of the jacks in the system at least 6 inches. Then press and hold the retract button until the jacks start to retract. All of the jacks should fully retract and the error should be cleared.
Usually about 15-minutes without power does it. Once reconnected to power if you still have error codes, such as “Out-of-Stroke”, to clear this code you can extend all of the jacks in the system at least 6 inches. Then press and hold the retract button until the jacks start to retract.
Why are the leveling jacks on my RV not working?
We’ve had a handful of members write in wondering what to do when the leveling jacks on their RV’s slide room, fifth wheel or tow trailer aren’t working properly. For most of these cases, their hydraulic system has either taken on a disturbing growling noise upon descension of the leveling jacks or they simply won’t retract back into the rig.
