How do you reset Aqua Trol?
To reset, turn the unit to Off and then back to Auto. Wait for the relay to click (5 to 10 seconds). Desired Output % Dial 1 to 100% sets the level of cell operation in % of operating time.. Example: 50% (factory default) cell is operating and generating chlorine 50% of the total pump/filter operating time.
What do you do when your pool says no flow?
The most common reason for low or no flow is that the baskets are full of debris. By checking and emptying both the skimmer basket (by the pool) and the pump basket (inside the pump) this will free up the water flow, allowing the system to fully ‘prime’ and function at full capacity.
What does default mean on Goldline SWG panel?
Press the diagnostic button once. Default = what the unit thinks the salt level is due to an average of all previously recorded “instant salt readings†from all of the different polarity changes since the system was installed, or since the last time the unit was recalibrated.
How can I recalibrate my Goldline pool panel?
You can do this by purchasing a salt meter or salt water test strips, or take the more practical approach of visiting a local pool store with a water sample. Any good pool store will do computerized water testing and salt checks. If your salt reading is different from that of the pool stores we will recalibrate your cell to the pool stores reading.
When was the Goldline Aqua logic pool controller installed?
My pool was installed in March 2006 by a pool company with a Goldline Aqua Logic Pool controller AQL-P4. This controller serves to control the electrical systems of the pool- generating chlorine and the filter.
Is it normal for Goldline units to be off 600 ppm?
It is normal for the Goldline units to be off as much as 600 ppm from a chemical test because they are measuring conductivity and not chloride ions. The older units were not temperature compensated so that could introduct another error when compared to a temperature compensated meter. It is acceptable.
Press the diagnostic button once. Default = what the unit thinks the salt level is due to an average of all previously recorded “instant salt readings†from all of the different polarity changes since the system was installed, or since the last time the unit was recalibrated.
You can do this by purchasing a salt meter or salt water test strips, or take the more practical approach of visiting a local pool store with a water sample. Any good pool store will do computerized water testing and salt checks. If your salt reading is different from that of the pool stores we will recalibrate your cell to the pool stores reading.
My pool was installed in March 2006 by a pool company with a Goldline Aqua Logic Pool controller AQL-P4. This controller serves to control the electrical systems of the pool- generating chlorine and the filter.
How to reset the Goldline / Hayward SWG panel?
To reset these light just push the black selector button in for 3 to 5 seconds and this will reset the trouble lights. After about an hour my readings were… Average 3200 and instant 3400 which is more in line with my tests. This also removes all past salt averages that may be in memory.
