How do you reset aqua pure salt?
Press and hold the ‘Pool Temperature’ (‘D’) key for 15 seconds. The system will beep when the button is pushed, it will beep again after 10 seconds, and again after 15 seconds. Release the key after the third beep. Press ‘Salinity’ (‘C’) key within 5 seconds to enter temperature change screen.
What is code 172 on Jandy aquapure error code?
Salinity sensor sees less than .2 GPL of salt. Either there’s no salt in the pool or sensor is air locked. Flow salinity sensor temperature probe error codes. 1.They all generates code 172- Flow sensor service is required. 2. Perform diagnostic test on board to ensure the board isn’t faulty. If not the board, the tri-sensor is the culprit. 3.
Which is error code is your Jandy unit displaying?
So, which error code is your Jandy unit displaying? Level 1 service codes are more common than level 2 codes and can typically be troubleshooted by the homeowner and a Jandy technical representative.
How to change a Jandy aquapure power supply?
3. How To Change a Jandy AquaPure Tri-Sensor Front board power supply is either too low or too high. 1. Generates code 173- Low input voltage, IF code 188 is present. 2. Generates code 170 IF 188 is not present. VAC input voltage too low. Relay not conducting in the forward direction. Relay not conducting in the reverse direction.
Why is there an error code on my Jandy chlorine generator?
It becomes especially difficult if the product, like the Jandy AquaPure Chlorine Generator, only displays an error code, but not necessarily what the error code means nor solutions to the problem. If you purchased the unit a year ago, it’s quite possible you may have misplaced or thrown out the manual. How will you diagnose the issue then?
How to troubleshoot Jandy aquapure error code 172?
Check salinity with Myron “L” meter calibrated for NaCl or test strips. Add salt as necessary Heated sensor element not heating. (Generates 172 code) Contact a pool professional. Flow sensor temperature sensor failure. (Generates 172 code – flow sensor service) Contact a pool professional.
What does code 125 mean on Jandy aquapure?
The error code 125 is indicative that the cell will need to be cleaned and/or replaced. There are a few additional steps you can take to try and determine exactly what the issue is. 1) Inspect DC cord and cell for damage, also inspect cell for calcium buildup and debris. If damaged replace parts or entire unit.
What to do if you get a Jandy error code?
1. Recalibrate salt reading. 2. Backwash your filter if a DE filter is installed. 3. Partially drain your pool and dilute with fresh water until salinity level returns to 3.0. 1. Typically caused by low AC voltage from back board. Check the transformer and back board.
What to do if your Jandy pool sensor is not working?
Jandy recommends that you contact a pool professional for service if you encounter a Level 2 code. Heated sensor element not heating. (Generates 172 code) Contact a pool professional. Flow sensor temperature sensor failure. (Generates 172 code – flow sensor service)
