How do you reset a Sapphire Spa?
In the past when a controller has entered an error condition it has been possible to reset the controller by turning the power to the controller off then on again. The controllers are now reset differently, in the event of an error condition the controller can now be reset by pushing a combination of touch pad buttons.
How do I drain my Sapphire Spa?
Locate the drain valve towards the base of your spa cabinet and pull cap out from the housing approximately 2” until it snaps into place. Depending on bather usage and the type of sanitising system used, your Sapphire Spa needs to be drained regularly every two to four months.
Why does my Spa have an error 6 code?
An error 6 code is due to no flow in the spa. Firstly make sure that all jets, waterfalls are all open. Waterfalls being closed will also result in the filtration pump not pumping enough water through to the heater.
What’s the error code on my Sapphire spa?
Spa won’t heat above 88′. Getting an error code with what Spa won’t heat above 88′. Getting an error code with what appears to be ————. It was working fine and heated to 104′ a week ago. … read more Associates Degree Applied…
Are there any error codes on my hot tub?
A comprehensive list of spa & hot tub touchpad (also referred to as spaside or topside control panel) error / fault codes, operational messages and reminders to suit practically all spas that have ever been made and sold throughout the world are listed here and for download also.
What does fault code er-3 mean on Spa?
If the priming sequence is successful in clearing the air pockets from the plumbing normal spa operation will resume in automatic mode. If unsuccessful the spa controller will shut down and latch on fault code ER-3 Water Prime. Heater thermal trip activated.
An error 6 code is due to no flow in the spa. Firstly make sure that all jets, waterfalls are all open. Waterfalls being closed will also result in the filtration pump not pumping enough water through to the heater.
Spa won’t heat above 88′. Getting an error code with what Spa won’t heat above 88′. Getting an error code with what appears to be ————. It was working fine and heated to 104′ a week ago. … read more Associates Degree Applied…
What to do if your spa unit has er-3 error message?
Heater has been active and has had insufficient water flow over the element. Low or no water flow has caused the heater temperature to exceed its maximum limits and the spa control has shut down operation to prevent any damage to the heater unit Turn mains power OFF and wait 10-15 minutes for element to cool and thermal cut-out device to reset.
A comprehensive list of spa & hot tub touchpad (also referred to as spaside or topside control panel) error / fault codes, operational messages and reminders to suit practically all spas that have ever been made and sold throughout the world are listed here and for download also.
