How do you remove drive track on Maytronics dolphin?
Maytronics Dolphin Drive Track Removal 1. Remove the bottom plate with bag. 2. With the machine upside down, remove the screws holding the debris shield and remove the shield. 3. Remove the screws holding the side plate. 4. Gently pry off the sideplate. It may need much persuasion due to dirt buildup on the sideplate pegs that slide into the body.
What’s the serial number on a Maytronics dolphin?
I have a Dolphin Deluxe series number 107624AS34 which has served me well. The long blue cord that runs between the vacuum and the power supply has a short … What is the value of the D2 diode (between the two big blue resistors)?
Why is my Maytronics dolphin not working properly?
Heat will destroy the electrical components inside the case. Re-coil the cable after every use starting at the robot and working the twists outward to the plug. Chances are…if your cable will not float straight and is always being sucked into the robot, that cable has most likely been stored in a piled twisted mess.
What are the specifications for the Dolphin LX?
DOLPHIN DOLPHIN LX SPECIFICATIONS & FLOORPLANS Due to continued product improvement, National R. V., Inc. reserves the right to change materials, colors, specifications and prices at any time without notification. Copyright © 2004 by National R. V., Inc. 01/04
Maytronics Dolphin Drive Track Removal 1. Remove the bottom plate with bag. 2. With the machine upside down, remove the screws holding the debris shield and remove the shield. 3. Remove the screws holding the side plate. 4. Gently pry off the sideplate. It may need much persuasion due to dirt buildup on the sideplate pegs that slide into the body.
What to do if your dolphin does not move?
• If your power supply unit’s “POWER/ON” button does NOT light up at all, you may need a replacement power supply. Take it to your local dealer for further testing or call Maytronics. 2. My Dolphin’s power supply turns on, but the Dolphin does not move: • If the Dolphin doesn’t move at all, there could be a problem with your cable.
Why does my Maytronics dolphin not float straight?
Chances are…if your cable will not float straight and is always being sucked into the robot, that cable has most likely been stored in a piled twisted mess. Recoiling the cable takes all of 30 seconds and saves hours of aggravation. I have several photos including a photo of the inside of the motor housing. 1. Remove the bottom plate with bag. 2.
Why is Dolphin not starting on my computer?
The program can’t start because FTD2XX.dll is missing from your computer. Try re-installing the program to fix this problem.” A: This is a system error that shows up the first time you launch the software and haven’t plugged in the base unit.
What to do if your dolphin stops moving?
If your Dolphin moves a few feet but then stops, it could be there’s a drive train or impeller blockage to blame so have a closer look: • Inspect the impeller itself. • Inspect all tracks and brushes. • Remove any debris that’s visible. • Gently rotate the brushes by hand.
Why is my dolphin pool robot not moving?
If your pool robot doesn’t move at all, there may be a power cable error. (Was it run over by aliens?) If your Dolphin moves a few feet but then stops, it could be there’s a drive train or impeller blockage to blame so have a closer look: • Inspect the impeller itself. • Inspect all tracks and brushes. • Remove any debris that’s visible.
Chances are…if your cable will not float straight and is always being sucked into the robot, that cable has most likely been stored in a piled twisted mess. Recoiling the cable takes all of 30 seconds and saves hours of aggravation. I have several photos including a photo of the inside of the motor housing. 1. Remove the bottom plate with bag. 2.
